Regency L676S-NG1 installation manual Framing, Installed. See Diagram 3 for details

				INSTALLATION
	FRAMING
1) Frame in the enclosure for the unit with framing material. The framed		Note:	When constructing the framed opening, please ensure
opening for the assembled kit is 45-7/8" high x 43" wide x 24-1/2"			there is access to install the gas lines when the unit is
deep (1143mm x H 1092mm W x 622mm D). See Diagram 1. Also			installed. See Diagram 3 for details.
see Diagram 2 for corner installations.
IMPORTANT: Header must be metal stud. All other framing may
be of combustible type such as 2x4 / 2x6 framing materials.

INSTALLATION

Diagram 1

Framing

Note: The 24-1/2" flush framing depth (and the corner framing installation) are based upon 1/2" drywall around the perimeter of the fireplace on all three sides.

Diagram 2

Diagram 3

2)For exterior walls, insulate the enclosure to the same degree as the rest of the house, apply vapour barrier and drywall, as per local installation codes. (Do not insulate the fireplace itself.)

3)The unit does not have to be completely enclosed in a chase. You must maintain clearances from the vent to combustible materials: See "Clearances" section. Combustible materials can be laid against the side and back standoffs and the stove base.

IMPORTANT

If converting this unit to LP, it is highly recommened the conversion be done BEFORE the unit is slid into position for ease of conversion. See "Conversion from NG to LP" section for instructions.

Regency® L676S Direct Vent Gas Fireplace 11