
INSTALLATION
INSTALLATION
UNIT ASSEMBLY
PRIOR TO
INSTALLATION
The Top Facing Support, the Side Nailing Strips and the 2 Top Standoffs must be correctly positioned and attached to the top before unit is slipped into position.
SIDE NAILING STRIPS
The side nailing strips come attached to the unit. There are 2 plates on each side, one on the top and bottom that can be folded out as required.
The Finishing Template uses two magnets to attach itself to the flange on the left or right side of the unit (see diagram below). Install the facing material up to the outside edge (when facing the unit) of the finishing template. This template may be discarded after the facing material has been installed.
TOP STANDOFF ASSEMBLY
The top standoffs are shipped in a flat position and must be folded into shape and attached.
1)Remove the standoffs from the fireplace
top.
2) Take each standoff and bend into the correct shape. Bend up at the bend lines until the screw holes in the standoff and the pre- punched screw holes on the fireplace top line up.
3) Attach the standoff securely to the top with 2 screws per standoff (on opposite corners).
Side Nailing Strips shown folded out.
Finishing
Template
Left Side Flange
FINISHING TEMPLATE
In order to maintain a clean face; the L676S allows for a 1/8” in overlap of finishing material, such as rock or tile, on both the left and right hand sides of the unit (top and bottom sides do not allow for an overlap), this overlap must not be exceeded or the glass door will no longer open properly.
VENTING
INTRODUCTION
The L676S uses the "balanced flue" technology Co Axial system. The inner liner vents products of combustion to the outside while the outer liner draws outside combustion air into the combustion chamber thereby eliminating the need to use heated room air for combustion and losing warm room air up the chimney.
Note: These flue pipes must not be connected to any other appliance.
The gas appliance and vent system must be vented directly to the outside of the building, and never be attached to a chimney serving a separate solid fuel or gas burning appliance. Each direct vent gas appliance must use it's own separate vent system. Common vent systems are prohibited.
14 | Regency® L676S Direct Vent Gas Fireplace |