Hearth and Home Technologies CD4842MIR, CD4842MR Air Shutter Setting, Install Bottom Latch Cover

Figure 14.10 Installing Floor Cover

Install Bottom Latch Cover

•Insert bottom latch cover over existing shoulder screws. See Figure 14.11.

•Push down till the tabs lock in place.

Figure 14.11 Installing Bottom Latch Cover

Install Firescreen Assembly

•Thread screen onto screen rod making sure to thread all screen rings.

•Hold the mesh firescreen in one hand until you get the rod inserted into the side columns to prevent the mesh from falling off the rod.

•Insert one end of screen rod into the hole located in the column as far as it will go. See Figure 14.12

Figure 14.12 Insert Rod Into Side Columns

•Flex the rod and insert it into the hole in the column on the other side.

•Hook the center of the rod into the screen rod tabs.

•Spread firescreen to the edges of the firebox opening.

•Hairpin clips are shipped in place in a hole in the bottom of each column. After the screen is in place, squeeze clips and remove from holes. Thread clip through screen (one on each side), squeeze clip and re-insert into holes.

Note: The floor cover in the bottom front of the fireplace may be covering the UL labels. It is loose and can be removed/replaced.

N. Air Shutter Setting

Air shutter settings should be adjusted by a qualified installer at the time of installation. The air shutter is set at the factory for minimum vertical vent run. Adjust air shut- ter for longer vertical runs. See Figure 14.13.

•16 full turns of the shutter adjustment handle are required to move air shutter from fully open to fully closed.

•When the shutter adjustment handle is all the way down, the air shutter is in the closed position.

NOTICE: If sooting occurs, provide more air by opening the air shutter.

Closed

Figure 14.13 Air Shutter

Heatilator • Caliber Mesh CD Series-SIT Valve • 4040-849 Rev J • 06/08 57