Hearth and Home Technologies EDV3633L, EDV3633IL owner manual Lighting Instructions

		FOR YOUR SAFETY READ BEFORE LIGHTING								This appliance needs fresh air for safe operation and must
										combustion and ventilation air.
										be installed so there are provisions for adequate
				WARNING:	If you do not follow these instructions exactly, a					This appliance must be installed in accordance
					fire or explosion may result causing property
										with local codes, if any; if not, follow ANSI
					damage, personal injury or loss of life.					Z223.1 or, in Canada, current CAN/CGA-B149.
	A.	This appliance is equipped with an ignition device which					• If you cannot reach your gas supplier, call the fire			This appliance must be properly connected to a
		automatically lights the pilot. Do not try to light the pilot					department.			venting system in accordance with the
		by hand.				C.	Use only your hand to push in and move the gas control			manufacturer's installation instructions.
	B.	BEFORE LIGHTING smell all around the appliance area
										WARNING: Improper installation,
							lever or knob will not move by hand, don't try to repair it,
		for gas. Be sure to smell next to the floor because some					valve or turn the gas control knob. Never use tools. If the
		gas is heavier than air and will settle on the floor.					call a qualified service technician. Force or attempted			adjustment, alteration, service or maintenance
		WHAT TO DO IF YOU SMELL GAS
							repair may result in a fire or explosion.			can cause injury or property damage. Refer to
		• Do not try to light any appliance.				D.	Do not use this appliance if any part has been under			the owner's information manual provided with
		• Do not touch any electric switch; do not use any					water. Immediately call a qualified service technician to			the appliance. For assistance or additional
		phone in your building.					inspect the appliance and to replace any part of the			information consult a qualified installer, service
		• Immediately call your gas supplier from a neighbor's					control system and any gas control which has been			agency or the gas supplier.
		phone. Follow the gas supplier's instructions.
							under water.			CAUTION: Hot while in operation. Do not touch.
Heatilator				LIGHTING INSTRUCTIONS
										having flammable vapors away.
										Keep children, clothing, furniture, gasoline and other liquids
•	1.	STOP! Read the safety information above on this label.				5.	Wait five minutes to clear out any gas. If you then smell gas,
										WARNING RISK OF FIRE
	2.	Turn wall switch to the "OFF" position or thermostat to					STOP! Follow "B" in the safety information above on this label. If
Eclipse•
	4.	the lowest setting.					you don't smell gas, go to the next step.
		This appliance is equipped with an ignition device which					and turn on the wall switch or set the thermostat to the desired			not attempt to use with solid wood fuel or another type of fuel.
	3.	Turn off all electric power to the appliance.				6.	To turn on the burner, turn on all electric power to this appliance			This appliance is intended to burn a specified gas fuel only. Do
4049		automatically lights the pilot. Do NOT try to light the pilot					setting.			Do not attempt to modify or use any other type of gas burner
		by hand.				7.	If the appliance will not operate, follow the instructions "TO TURN			system.
-							OFF GAS TO APPLIANCE" and call your service technician or gas
			TO TURN OFF GAS TO APPLIANCE							WARNING: Disconnect the electric power before
229Rev
							supplier.
										servicing. If for any reason the original wire supplied with the
										appliance must be replaced, it must be replaced with 105° C or its
F •
	1.	Turn off wall switch or set thermostat to lowest setting.				3.	Push the gas control lever in and move to the "OFF"			equivalent.
11/08										For use with natural gas or propane. A conversion
	2.	Turn off all electric power to the appliance if service is to					position or push the gas control lever to the "OFF"
		be performed.					position. Do not force.			kit as supplied by the manufacturer shall be used
						4.	Replace the control access panel.			to convert this appliance to the alternative fuel.
									* Also certified for installation in a bedroom or
										a bed-sitting room.
									*	For U.S. only!
	Due to high surface temperatures, keep children, clothing and furniture away.										NATURAL GAS
	Keep burner and control compartment clean. See installation and operating instructions accompanying the appliance.
								33631D

11

tery life, remove them when using the	H. Lighting Instructions (IPI) The IPI system may be operated with
transformer.	two D-cell batteries
	.
	When using batteries, unplug the transformer. To prolong bat-