Hearth and Home Technologies EDV3633 Replace Glass, Grilles and Screen, Install Floor Cover

•Place a small amount of 1/2 in. (13 mm) diameter pieces (dime-size) of rockwool on the burner pan so that the rockwool touches but does not cover the holes in the burner pan. This will provide the “glowing embers” look. It is not necessary to use the entire bag. Save the remaining rockwool for future use. See Figure 14.6.

Figure 14.6 Placement of Rockwool

E. Replace Glass

Replace the glass assembly on the lower access latches and rotate the upper portion of the glass assembly into place. Engage the top access latches. Engage lower ac- cess latches.

G. Grilles and Screen

•Lay top grille face down so the thin tabs are pointing up.

•Spread screen out next to the tab side of the grille.

•Starting with one corner of the screen, thread the first loop of the screen over the first tab on top grille and continue threading the screen over tabs along edge of top grille. Adjust screen so it lays evenly (not bunched or too tight between tabs).

Tab

Figure 14.8 Lay Out Screen

•Bend tabs 90 degrees away from the screen with needle nose pliers to secure the screen to top grille. See Figure 14.9.

F. Install Floor Cover

Place floor cover (painted side up) as shown in Fig- ure 14.7.

Figure 14.7 Place Floor Cover

Figure 14.9 Bend Tabs to Hold Screen

•Place the tabs of the top grill over the shoulder screws on each end. See Figure 14.10.

Figure 14.10 Attach Top Grill - Left Side Shown

Heatilator • Eclipse • 4049-229 Rev F • 11/08 47