LG Electronics WG1805RY6 Disassembly, Mechanical Parts, Front Grille, Cabinet, Control Box

Disassembly

Disassembly

— Before the following disassembly, CONTROL BOX set to OFF and disconnect the power cord.

MechanicalParts

1.Front Grille

1.Open the lnlet grille upward .

2.Remove the screw that fastens the front grille.

3.Pull the front grille from the right side.

4.Remove the front grille.

5.Re-install the component by referring to the removal procedure, above.(See Figure 17)

NOTICE Mark " "of inlet grille means opening d irection.

2.Cabinet

1.After disassembling the FRONT GRILLE, remove the 2 screws that fasten the cabinet at both sides.

2.Remove the 2 screws that fasten the cabinet at back.

3.Pull the base pan forward. (See Figure 18)

4.Remove the cabinet.

5.Re-install the component by referring to the removal procedure, above.

3.Control Box

1.Remove the front grille. (Refer to section 17)

2.Remove the cabinet. (Refer to section 18)

3.Remove the 2 screws that fasten the control box cover.

4.Remove two housings that connect compressor wire and motor wire in the control box.

5.Discharge the capacitor by placing a 20,000 ohm resistor across the capacitor terminals.

6.Remove the 2 screws that fasten the control box.

7.Pull the control box forward completely.

8.Re-install the components by referring to the removal procedure, above. (See Figure 19)

(Refer to the circuit diagram found on page 23 in this manual and on the control box.)

Figure 17

Figure 18

Figure 19

15Room Air Conditioner