Singer XL-400 Center Hoop Marking Ligne Centrale du Cerceau Marca de Centro del Aro, Hacia abajo

In the case of a 2 hoop design, where one hoop is stacked on top of the other, position the Guide Lines on the horizontal cross line and the Center Hoop Marking on the vertical cross line. See Fig. 5.

Fig. 5

Fig. 5

Fig. 5

Guide line

Ligne Guide

Línea guía

Center Hoop Marking Ligne Centrale

du Cerceau

Marca de Centro del Aro

Center Hoop Marking Ligne Centrale du Cerceau Marca de Centro del Aro

Guide line

Ligne Guide

Línea guía

6.The next screen prompts you to input the first of three alignment points, A, B, and C. These alignment points will inform the machine exactly where the crosslines are positioned in the hoop. It is extremely important that the points are accurately input on the cross lines. The machine is awaiting the input of point A. See figure 3.

Use the shift buttons on the machine to move the hoop, until the needle comes to point A on the cross line, and push the OK button.

MULTIPLE HOOP SHIFT BUTTONS AND “CROSS LINE” INDICATOR LIGHTS FOR INPUTTING POINTS A, B, AND C

Upward
Vers le haut	Downward
Hacia arriba
Leftward	Vers le bas
	Hacia abajo
Vers la	Rightward
gauche
Hacia la	Vers la droite
izquierda	Hacia la
	derecha

Shift switch Commutateur de changement Interruptor de cambio

OK switch Commutateur d'acceptation

Interruptor OK

Clear switch

Commutateur de suppression Interruptor de borrado

Please Note: The buttons on the machine are lit to indicate the “cross line” positions of the fabric in the hoop. The blinking button is indicating the point to be input.

If a mistake is made when entering the points, press the clear button, (twin needle/clear button) to clear the point(s). and then re-enter point(s).

 

A

B C

92