Hoover Bagless Vacuum Cleaner manual Removable brushes, To remove brushes, To replace brushes

Page 15

Cleaning upholstery

Read “Before you begin cleaning” instructions on page 9.

Be sure to check the cleaning code on your upholstery. Use your deep cleaner only on upholstery marked “W” or “W/S”.

1.Attach hose and solution tube as instructed in Figs. 3-10 to 3-12.

2.Place handle in upright position.

Agitator brushes will not rotate while handle is in upright position.

3.Fill clean water tank according to instructions for Figs. 2-9 to 2-12.

4.Fill detergent container with HOOVER Carpet/Upholstery Detergent according to instructions for Figs. 2-13 to 2-14.

5.Attach tool to end of hose.

Do not point tools toward people or pets.

6.Dry hands and plug deep cleaner into a properly grounded outlet.

7.Set Wash/Rinse switch to WASH. Turn cleaner ON.

3-22

8.Gently press the tool onto the fabric. Press the trigger and slowly pull the noz- zle over the fabric.

9.Overlap strokes by 1/2 inch to help prevent streaking.

Make additional strokes without pressing the trigger to remove more moisture.

10.To clean in corners or creases, lift the tool one-half inch from the fabric and press the solution trigger.

11.Vacuum up the solution with the tool without pressing the trigger.

12.For heavily soiled areas, it may be necessary to repeat the cleaning process. Make crisscrossing strokes to the original pattern; overlap each pass (Fig. 3-23).

3-23

Make no more than 2 passes with the solution or rinse over any one area to prevent over-wetting and damage to fabric.

If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again.

13.Empty recovery tank when the motor sound becomes higher pitched and there is a loss in suction (see “Automatic shut-off”, Fig. 2-6).

When finished cleaning, follow “After cleaning” instructions on pages 9 & 10 and “After using tool” instructions on page 12.

4. Maintenance

Removable brushes

Your deep cleaner is equipped with removable brushes for easy cleaning.

To remove brushes

Disconnect cleaner from electrical outlet.

To prevent possible leaking, remove clean water tank and recovery tank. Set tanks aside.

4-1

With handle in upright position, tilt cleaner back until handle rests on the floor.

4-2

Grab brush assembly and pull firmly.

The brushes can be cleaned under run- ning water.

4-3

B

D

B

 

 

 

A

 

 

 

A

 

 

 

 

C

 

 

To replace brushes

Align posts (A) on both ends of brush assembly with slots (B) in cleaner hous- ing.

Make sure that the square post (C) also aligns with the square hole (D). Turn brushes slightly until post fits easily into hole.

Press brush assembly firmly to snap into place.

Continued ➜

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Easy to Use Deep Cleaner Deep CleanerGrounding Instructions Important SafeguardsAssembly ContentsAttach upper handle Attach hose/cord hookAttach hose/tool caddy Storing hose and tools SpinScrub hand toolHose Hose/tool caddy Stair/upholstery nozzle How to reattach tool coverON/OFF switch Wash/Rinse switch Hand gripTo transport ON/OFF switchBrush setting selector Handle release pedalTanks Wash/rinse switchClean water tank How to fillLower tank Recovery tankHow to empty Turn deep cleaner off and unplug from electrical outletAfter cleaning Before you begin cleaningTurn brushes on or OFF as desired To clean nozzleRead Before you begin cleaning instructions on Do not clean over floor electrical out- letsAttach hose How to attach bare floor attachmentTo clean floor Unplug cleaner from electrical outletAttaching scrub module How to attach toolsAfter using tool Select toolAfter using scrub tool Using the scrub toolTo replace brushes Disconnect cleaner from electrical outletRemovable brushes To remove brushesClean water tank not firmly in place 5Possible. Ifcauseyou have a Possible solutionRecovery tank full/automatic shut off engaged Recovery tank lid not on correctlyCenter or Authorized Hoover Warranty Service Dealer Depot by Full One Year Warranty Domestic UseManual del Proprietario ¡Salvaguardias importantesLa limpiadora en Profundidad fácil de Usar Instale el mango superior EnsambladoPiezas necesarias para el ensamblado Instale el gancho para la manguera/cordónComo volver a colocar la cubierta de accesorios Accesorio de mano SpinScrubTMCómo usar la limpiadora en profundidad Para guardar la manguera y los accesoriosPara transportarla Interruptor de encendido y apagado ON/OFFCómo llenar Pedal para destrabar el mangoTanque inferior Cómo limpiarTanque de recuperación Cómo vaciarPara limpiar la boquilla Después de la limpiezaApague y encienda las escobillas como desee Para sacar la manguera Cómo instalar el accesorio para pisos expuestosPara limpiar el piso Coloque la mangueraDespués de usar el accesorio Cómo conectar los accesoriosInstalación del módulo de refregar Uso del accesorio para refregarAlmacenamiento Si tiene un problemaMantenimiento Escobillas removiblesGarantía completa de un Año ServicioFrançais p Guide de ’utilisateurConsignes de sécurité importantes La shampouineuse facile à utiliserFixer la section supérieure du manche Fixer le plateau de rangement pour tuyau/accessoireAssemblage Pièces nécessaires pour l’assemblageUtilisation Interrupteur lavage/rinçage Poignée de transportArrêt automatique Sélecteur de vitesse de la brosseAvant de commencer le nettoyage NettoyageVidage du réservoir Réservoir de récupération réservoir inférieurNettoyage de l’embout Nettoyage de tapisNe pas passer l’appareil sur des prises de courant au sol Après l’utilisation de l’accessoire Choix d’accessoiresComment fixer les accessoires Utilisation d’accessoires Fixer le tuyauNettoyage d’escaliers avec tapis Utilisation l’accessoire de frottageAprès l’utilisation de l’accessoire de frottage Fixation du module de frottageDépannage EntretienPour remplacer les brosses Garantie Complète de un an ServicePage
Top Page Image Contents