FFO | ASHW |
|
NO | nseiR |
|
ON/OFF switch
To turn cleaner ON, push switch down.
To turn cleaner OFF, push switch up.
A |
Handle release pedal
Step on pedal (A) to lower handle to operating position. Handle does not lock into a single position but “floats” to allow convenient operation.
To transport
To move your deep cleaner from room to room, put handle in upright and locked position, tilt deep cleaner back on wheels and push forward.
Carrying handle
The deep cleaner may also be lifted by placing a hand above the upper clean solution tank handle as shown.
B |
Automatic shut off
When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the deep cleaner suction (suction will be noticeably reduced).
At that time, the yellow float disk will rise to the top of the recovery tank lid (B). The deep cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch.
When this happens, turn deep cleaner off and empty recovery tank before continuing use.
Check clean water tank also; it may need to be refilled.
Do not use without float and float retainer in place. If broken or dis- lodged, take to an Authorized Hoover Service Center or Dealer for repair.
Brush setting selector
Your ‘SteamVac’ deep cleaner has two agitator brush settings.
ON - for cleaning of carpet and bare floors
OFF - for cleaning carpets and bare floors when brushing is not desired.
Slide selector button to the desired set- ting before cleaning.
Continued ➜ 7