Baldor iMN1800 manual Lmnm Moving Magnet Type Non Commutated DC Linear Servo Motor

LMNM Moving Magnet Type Non Commutated DC Linear Servo Motor

General Description: Bi–directional DC linear motor with integral bearing. (Refer to catalog BR1 800 for motor specifications, if your motor is custom; refer to documentation included with shipment or contact Baldor)

Construction:Anodized aluminum or plated steel housing, aluminum end–caps, steel center shaft. Your motor may or may not be supplied with a mounting flange or other mounting provisions refer to catalog BR1 800 for standard motor specifications or refer to documentation included with shipment for custom motors.

Bearing type:Depending on motor catalog number the bearing may be one of the following: linear, anti rotational linear, rulon, sapphire, or flexure. Refer to catalog BR1 800. If your motor is custom, refer to documentation included with shipment. Maintenance: Motor should be kept dry and relatively free of contamination. This motor is NOT WATER PROOF. Avoid submersion. These motors are factory assembled and aligned, the bearings must be serviced by Baldor or a Baldor authorized repair center. Disassembly of motor will void warranty. Avoid contact with petroleum based solvents. Alcohol can be used to remove contaminants. Contact your local Baldor representative for service information.

Motor specifications: Refer to catalog or outline drawing supplied with motor for mechanical dimensions and electrical specifications.

Motor Mounting:Refer to catalog or outline drawing supplied with motor for mounting details and hole dimensions. When attaching payload to motor, avoid axial loading of the motor shaft. Axial loading can damage the bearing thus reducing its life. If your motor is supplied with drilled and tapped mounting holes, refer to the recommended seating torque for screws in this document. It is recommended that a thread locking compound be used with mounting screws.

Electrical Connections For voltage and current specifications, refer to Catalog BR1800 or to documentation enclosed for custom motors. Your motor is supplied with 24 inch flying leads*. These wires can be cut to remove excess length if required. Connectors are available; contact a Baldor representative for more information.

(optional on some models)

*If your motor was supplied with custom cables; refer to enclosed documentation for any custom motor designs.