Conair CHS-810 manual Then install the front, fixed knife, Service

Then install the front, fixed knife

16Install the knife in the knife attachment.

17Screw in the socket cap screws (C) and tighten so that the support rule (D) lightly supports the knife.

18Press the knife firmly into the knife attachment.

✐NOTE: The screws in the rear of the knife attachment are bonded in place.

✐NOTE: The knife has a fixed position and no adjustment may be done.

19	Tighten the screws (C), with alternating
20	tightening torque to 29.5 lb-ft (40 Nm).
	Carefully check that all rotating knives
	can pass the front fixed knife.	D C
	If any knife can not pass the front fixed knife freely

–undo the screws (C) and press the knife firmly into the knife attachment.

21Check the clearance of each rotating knife with a feeler gauge The clearance should be 0.008 - 0.012 in. (0.20 - 0.30 mm), check at the outer edges of the knives.

22Re-check the tightening torque of all rotating knives (55.3 lb-ft [75 Nm]; granulator with open cutter 162.3 lb-ft [220 Nm]).

23Re-check the tightening torque of the front and rear fixed knives (29.5 lb-ft [40 Nm]).

7 Service

S e r v i c e l 7 - 5