Electrolux SIG 556 Pressure Testing, Checking The Grill, Checking The Hotplate

Page 49
FIT A 3 AMP FUSE TO THE PLUG HOLDER.

If the wiring is extended or a completely new cable fitted a 3-pin 13 amp plug should be fitted. (See Fig.4a). Connect the wires as follows:

BROWN to the Live Terminal. BLUE to the Neutral Terminal.

GREEN and YELLOW to the Earth Terminal.

As the colours of the wires in the mains lead which you fit may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is GREEN and YELLOW must be connected to the terminal in the plug which is marked with the letter 'E' or by

the earth symbol or coloured GREEN or GREEN and

YELLOW.

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter 'N' or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter 'L' or coloured RED.

FIT A 3 AMP FUSE TO THE PLUG HOLDER.

Ensure that the supply cable cannot get caught by the stability bracket.

Fig.4a

Plug in the appliance.

6. PRESSURE TESTING

1The oven injector is used as a pressure test point.

Remove the oven furniture. Remove oven burner box retaining clips (one spring clip from each side) and remove box front cover. Replace one clip back into the right hand side of the burner box.

Remove oven burner by removing the spring clip from the right hand side of the oven burner and slide burner off injector whilst easing it forward and taking care not to strain the F.S.D. phial.

2.Connect the pressure gauge to the oven injector.

3.Check the supply pressure by turning the thermostat on and one hotplate tap full on and light the appropriate burner. The pressure should be either:-

(i)For Natural Gas 20mbar

(ii)For LP.GasThe pressure must be set to 28 mbar for use on butane or 37 mbar for use on propane.

4.Turn off the taps, disconnect the pressure gauge and replace oven burner and cover, ensuring that the F.S.D. phial is correctly located into the bracket on the burner.

5.Check operation of oven.

7. CHECKING THE GRILL

Place the grill pan containing the grid, with the handle attached, into the grill compartment. Light the grill burner by turning the grill tap to its full on position and pushing the ignition button. As soon as the burner is lit the button can be released.

8. CHECKING THE HOTPLATE

Lift the lid. Fit the burner crowns and caps ensuring that they are correctly seated. Fit the pan supports. Check each of the hotplate burners in turn by turning the hotplate tap to it's full on position and pushing the

ignition button. As soon as the burners are lit the button can be released.

9. CHECKING LID SHUT-OFF DEVICE

1.Lift the lid.

2.Turn one hotplate burner tap to its full on position and push the ignition button.

3.Close lid. There should now be no gas supply to the hotplate and the burner will go out.

4.Turn off the hotplate tap and lift the lid. The gas supply should now be restored to the hotplate. When the tap is turned on.

49

Image 49
Contents Operating and Installation Instructions Introduction For your safetyS I G 5 5 RATING PLATEContents ContentsHotplate Lighting the applianceLighting the appliance To lightGrill Grill/second ovenSecond oven To turn off any burner Main ovenOven light The grill Prior to using the grillHeat control The grillGeneral Cooking positionsPreheating Positioning food on the gridThe grill pan and handle Burner sizes The hotplateThe hotplate Take care to avoid burns and scalds when you the flames lick round the sides of the Helpful hintsquickly and there will be less steam in This way they will cook more quicklyHeat zones The ovensOven shelves The ovensBaking trays and dishes Condensation RoastingOven cooking chart Oven cooking chart - Main ovenTurkey below 4.5kg 10lbs 0.90 kg 2 lb loaves Bread 0.45 kg 1lb loavesOven cooking chart - Second oven on a metal plate, or if plates are flat and 3½ - 4½ hoursTo help pastry brown on the underside cook have no rim underneath, place on bakingS I G To use the Timer The electronic timerThe electronic timer To set the time of dayAutomatic control Setting the controls for automatic useshows in the display. The Hints and tips for automatic cooking Food preparation - slow cooking Slow cookingSlow cooking Vegetables S I G 5 5 Soups, casseroles and stewsMilk puddings General points for slow cooking Frozen foodsCleaning the handles and control knobs Care and cleaning For your safetyCare and cleaning The hotplate When replacing hotplate burner partsThe grill and oven furniture The grillThe ovens least 30 minutes Main oven cleaning cycleMARK Top oven cleaning cycleMARK To remove the outer glass Cleaning between the outer and inner door glassInstalling the appliance Cleaning The Door GlassInstallation LocationPositioning Appliance dimensionsConnecting to the electricity supply General information For your safetyMoving your appliance General informationReplacing the oven light bulb What is wrong and why? What is wrong and why?Problem CheckHaving difficulty cleaning any part of the appliance S I G 5 5 ProblemThe oven light will not work Servicing Service and spare parts0 8 7 0 5 9 2 9 9 The Gas Consumers Council Customer Care DepartmentSerial number on front frame. Rating Plate on top rear of panel INSTALLATION INSTRUCTIONSDIMENSIONS TECHNICAL DATACONNECTIONS GRILLMAIN OVEN IMPORTANT - SAFETY REQUIREMENTSSECOND OVEN GENERALLOCATION OF APPLIANCE All dimensions in mm100 less than 400 Fig.1a1. PARTS REQUIRED INSTALLATION2. LEVELLING THE APPLIANCE 3. FITTING THE STABILITY BRACKET5. CONNECTION TO THE ELECTRICITY SUPPLY 4. CONNECTING TO GAS7. CHECKING THE GRILL 6. PRESSURE TESTING8. CHECKING THE HOTPLATE 9. CHECKING LID SHUT-OFF DEVICE11. CHECKING THE MAIN OVEN 10. CHECKING THE MAIN OVEN CONTROLS12. AUTOMATIC OPERATION TO SET THE TIME OF DAY see Fig.514. CHECKING THE MAIN OVEN LIGHT 13. CHECKING THE SECOND OVENGENERAL NOTE N O T E S N O T E S SIG 556 Contents Check List PARKINSON COWAN 55 - 77 HIGH STREET SLOUGH BERKSHIRE SL1 1DZ IMPORTANT NOTICETELEPHONE 0870 5 Part Number311625804