Denon DRA-395 manual Connections, Connecting the audio components, Them for hair driers, etc

ENGLISH

5

CONNECTIONS

•	Do not plug in the power cord until all connections have been	•	Note that binding pin plug cords together with power cords or
	completed.		placing them near a power transformer will result in generating
•	Be sure to connect the left and right channels properly (left		hum or other noise.
	with left, right with right).	•	If hum or other noise is produced when the ground wire is
•	Insert the plugs securely. Incomplete connections will result in		connected, disconnect it.
	the generation of noise.	• Noise or humming may be generated if a connected
•	Use the AC OUTLETS for audio equipment only. Do not use		component is used independently without turning the power of
	them for hair driers, etc.		this unit on. If this happens, turn on the power of the this unit.

Connecting the audio components

									OUTPUT
Turntable (MM cartridge)									R	L
NOTE:									R	L
This unit cannot be used
with	MC	cartridges								OUT
directly. Use a separate
head amplifier or step-										LINE
up transformer.
								Ground
								wire
					R	L
							PHONO		ZONE 2
							IN		MULTI
								SIGNAL	ROOM
							CD
			LOOP	AM				GND	ZONE 3
									OUT
			ANT.				L
									DVD/
						R	VDP		VDP
									IN
				FM
				COAX.			V. AUX		V. AUX
				75
			ANTENNA	L
			TERMINALS				VCR		VCR
			PRE OUT	R
			SUB				CDR/		MONITOR
			WOOFER				TAPE
		R
				ZONE					OUT
							VCR		VCR
				2
		L					OUT
			R	L					VIDEO
				ZONE			CDR/	IN	OUT
			OUT	3			TAPE
			MULTI ROOM		R	L	AUDIO	ROOM TO ROOM (REMOTE CONTROL)
			R	L	R		L

OUT	LINE IN
LINE

Tape deck

CD player

Connecting a CD player

Connect the CD player’s analog output jacks (ANALOG

OUTPUT) to this unit’s CD jacks using pin plug cords.

AC CORD

AC 120 V, 60 Hz

	SPEAKER SYSTEMS			AC OUTLETS
B			A	AC 120V 60Hz
R	L	R	L	SWITCHED
				TOTAL 120W(1A.) MAX.
SPEAKER IMPEDANCE
A OR B / 4	16
A + B / 8	16
	AUX OUT
Sub room (ZONE 2)				RC-616 (Sold Separately)
RC-617 (Sold Separately)				Infrared retransmitter
Infrared sensor
+		+
				+

R L R L

R L R L

OUTPUT INPUT

Connecting a tape deck

Connections for recording:

Connect the tape deck’s recording input jacks (LINE IN or REC) to this unit’s tape recording (OUT) jacks using pin plug cords.

Connections for playback:

Connect the tape deck’s playback output jacks (LINE OUT or PB) to this unit’s tape playback (IN) jacks using pin plug cords.

		OUTPUT INPUT	INPUT
	Power amplifier
		Sub room (ZONE 3)
INPUT	Power amplifier	RC-617 (Sold Separately)
		Infrared sensor

+

OUTPUT

Connecting the AC OUTLETS

AC OUTLETS

•SWITCHED (total capacity – 120 W (1 A.)

The power to this outlet is turned on and off in conjunction with the POWER operation switch on the main unit, and when the power is switched between on and standby from the remote control unit.

No power is supplied from these outlets when this unit’s power is at standby. Never connect equipment whose total capacity is above 120 W (1 A.)

NOTE:

Use the AC OUTLETS for audio equipment only. Do not use them for hair driers, etc.

6