Hoshizaki FD-1001MRH(-C) FD-1001MWH-C Condenser, Connection, To a Potable, Water Supply

2. Water-Cooled Condenser

a) Connection to an Open Drain System

•Condenser water supply inlet is 1/2" female pipe thread (FPT). A minimum of 3/8" OD copper tubing is recommended for the condenser water supply line.

•A condenser water supply line shut-off valve and drain valve should be installed.

•Condenser drain outlet is 3/8" FPT. A minimum of 3/8" OD hard pipe is recommended for the condenser drain line.

•In some areas, a back flow preventer may be required in the cooling water circuit.

FD-1001MWH(-C)

Condenser	Condenser Drain
Connection	Outlet 3/8" FPT
to a Potable	Icemaker/Condenser
Water Supply
	Water Supply Line
	Shut-Off Valve
	Condenser Water
	Supply Inlet
	1/2" FPT
	Icemaker/Condenser
	Water Supply Line
	Drain Valve

To convert to top water supply, install the optional Top Water Supply Kit (HS-2123).

Icemaker Water

Supply Inlet

1/2" FPT

Icemaker Icemaker

Drain Outlet

3/4" FPT

Separate piping to approved drain. Leave a 2-inch (5-cm) vertical air gap between the end of each pipe and the drain.

2-inch (5-cm) air gap

Bin Drain Outlet 3/4" FPT

Storage Bin

Drain Floor

Fig. 15

28