Hoshizaki FD-1001MAH(-C), FD-1001MRH(-C) Specifications Nameplate Rating, FD-1001MAH-C air-cooled

Page 6

I. Specifications

A. Nameplate Rating

1. FD-1001MAH(-C) (air-cooled)

HOSHIZAKI ICE MAKER

MODEL NUMBER

FD-1001MAH

SERIAL NUMBER

208-230/60/1 (3 WIRE

AC SUPPLY VOLTAGE

COMPRESSOR

WITH NEUTRAL FOR 115V)

240V 4.2RLA 34LRA

GEAR MOTOR

120V 3.0FLA 1/4HP

FAN MOTOR

115V 0.85FLA 1/15HP

OTHER

120V 0.03A

MAXIMUM FUSE SIZE

15

AMPS

MAX HACR BREAKER (USA ONLY)

15

AMPS

MAX CIRC BREAKER (CANADA ONLY)

15

AMPS

MINIMUM CIRCUIT AMPACITY

15

AMPS

DESIGN PRESSURE

HI-427PSI LO-230PSI

REFRIGERANT

404A 1 LB 12 OZ.

MOTOR-COMPRESSOR THERMALLY PROTECTED,

NOT INTENDED FOR OUTDOOR USE!

Hoshizaki America, Inc.

Peachtree City, GA

www.hoshizaki.com

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ICE MAKER WITHOUT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

STORAGE MEANS

COMPONENT

 

946Z

 

186090

Note: Only the "MODEL NUMBER" is replaced for FD-1001MAH-C.

See the nameplate for electrical and refrigeration specifications. This nameplate is located on the rear panel.

Since this nameplate is located on the rear panel of the icemaker, it cannot be read when the back of the icemaker is against a wall or against another piece of kitchen equipment. Therefore, the necessary electrical and refrigeration information is also on the rating label, which can be easily seen by removing only the front panel of the icemaker.

We reserve the right to make changes in specifications and design without prior notice.

Image 6
Contents Superior Degree Reliability Hoshizaki AMERICA, INC Contents Page Indicates important information about the use and care Important Safety InformationSerious injury UnitSpecifications Nameplate Rating FD-1001MAH-C air-cooledFD-1001MWH-C water-cooled FD-1001MRH-C remote air-cooled FD-1001MLH-C low-side, parallel rack system Dimensions / Connections FD-1001MWH-C water-cooled FD-1001MRH-C remote air-cooled FD-1001MLH-C low side, parallel rack system How to Remove Panels II. Installation and Operating InstructionsChecks Before Installation See FigSetup LocationElectrical Connection For All ModelsAdditional Warnings for Remote Air-Cooled Model Installation of Remote Condenser Unit Checks Before InstallationLocation Setup Line SetField Fabricated Line Set Installation Polyol Ester POE OIL Electrical Connection Stacking Remote Condenser Units Line Set Installation Connection to an R-404A Parallel Rack SystemRack System-Braze Connection Entire Male Fitting Water Supply and Drain Connections See , 15, orFD-1001MAH-C FD-1001MRH-C FD-1001MLH-C IcemakerTo a Potable FD-1001MWH-C CondenserConnection Water SupplyFD-1001MWH-C Connection toClosed Loop Final Checklist Startup Bin Control Check Infrared Sensor CheckThumbscrew Infrared Sensor Housing Lens Mechanical Backup Bin Control Check Infrared Sensor Shutdown Delay Seconds 1.6 minutesCleaning Solution III. Cleaning and MaintenanceCleaning and Sanitizing Instructions Cleaning ProcedureFloat Switch Assembly Reservoir Cover Infrared Sensor Infrared Sensor Housing Lens Sanitizing Solution Sanitizing Procedure InitialSanitizing Procedure Final Maintenance Frequency Area TaskPreparing the Icemaker for Long Storage Remove the water from the icemaker water supply lineDrain the evaporator Page Hoshizaki AMERICA, INC