Hoshizaki FD-1001MLH(-C), FD-1001MRH(-C) FD-1001MLH-C low-side, parallel rack system

Page 9

4. FD-1001MLH(-C) (low-side, parallel rack system)

HOSHIZAKI ICE MAKER

MODEL NUMBER

FD-1001MLH

SERIAL NUMBER

115-120/60/1

AC SUPPLY VOLTAGE

COMPRESSOR

--- --- ---

GEAR MOTOR

120V 3.0FLA 1/4HP

FAN MOTOR

--- --- ---

OTHER

120V 0.53A

MAXIMUM FUSE SIZE

15

AMPS

MAX. HACR BREAKER (USA ONLY)

15

AMPS

MAX. CIRC. BREAKER (CANADA ONLY)

15

AMPS

MINIMUM CIRCUIT AMPACITY

15

AMPS

DESIGN PRESSURE

HI-427PSI LO-230PSI

REFRIGERANT

 

404A

MOTOR-COMPRESSOR THERMALLY PROTECTED,

NOT INTENDED FOR OUTDOOR USE!

Hoshizaki America, Inc.

Peachtree City, GA

www.hoshizaki.com

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ICE MAKER WITHOUT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

STORAGE MEANS

COMPONENT

 

946Z

 

186090

Note: Only the "MODEL NUMBER" is replaced for FD-1001MLH-C.

See the nameplate for electrical and refrigeration specifications. This nameplate is located on the rear panel.

Since this nameplate is located on the rear panel of the icemaker, it cannot be read when the back of the icemaker is against a wall or against another piece of kitchen equipment. Therefore, the necessary electrical and refrigeration information is also on the rating label, which can be easily seen by removing only the front panel of the icemaker.

We reserve the right to make changes in specifications and design without prior notice.

Image 9
Contents Superior Degree Reliability Hoshizaki AMERICA, INC Contents Page Serious injury Important Safety InformationIndicates important information about the use and care UnitFD-1001MAH-C air-cooled Specifications Nameplate RatingFD-1001MWH-C water-cooled FD-1001MRH-C remote air-cooled FD-1001MLH-C low-side, parallel rack system Dimensions / Connections FD-1001MWH-C water-cooled FD-1001MRH-C remote air-cooled FD-1001MLH-C low side, parallel rack system Checks Before Installation II. Installation and Operating InstructionsHow to Remove Panels See FigLocation SetupElectrical Connection For All ModelsAdditional Warnings for Remote Air-Cooled Model Installation of Remote Condenser Unit Checks Before InstallationLocation Line Set SetupField Fabricated Line Set Installation Polyol Ester POE OIL Electrical Connection Stacking Remote Condenser Units Connection to an R-404A Parallel Rack System Line Set InstallationRack System-Braze Connection Entire Male Fitting See , 15, or Water Supply and Drain ConnectionsIcemaker FD-1001MAH-C FD-1001MRH-C FD-1001MLH-CConnection FD-1001MWH-C CondenserTo a Potable Water SupplyFD-1001MWH-C Connection toClosed Loop Final Checklist Startup Infrared Sensor Check Bin Control CheckThumbscrew Infrared Sensor Housing Lens Mechanical Backup Bin Control Check Seconds 1.6 minutes Infrared Sensor Shutdown DelayCleaning and Sanitizing Instructions III. Cleaning and MaintenanceCleaning Solution Cleaning ProcedureFloat Switch Assembly Reservoir Cover Infrared Sensor Infrared Sensor Housing Lens Sanitizing Procedure Initial Sanitizing SolutionSanitizing Procedure Final Frequency Area Task MaintenancePreparing the Icemaker for Long Storage Remove the water from the icemaker water supply lineDrain the evaporator Page Hoshizaki AMERICA, INC