11)Wipe down the infrared sensor's lens, (located on the bottom of the icemaker) with the cleaning solution. See Fig. 22. Next, rinse the cleaning solution off of the infrared sensor's lens with a clean, damp cloth.
Infrared Sensor 
Infrared Sensor Housing
Fig. 22 | Lens |
|
12)Move the control switch to the "ICE" position, then move the power switch to the "ON" position. Replace the panels in their correct positions. Turn on the power supply and make ice using the solution until the icemaker stops making ice.
13)Turn off the power supply, then remove the front panel. Move the control switch to the "DRAIN" position, then replace the front panel in its correct position.
14)Turn on the power supply and allow the solution to drain for 5 minutes.
15)Turn off the power supply, then remove the front panel. Move the control switch to the "ICE" position, then replace the front panel in its correct position.
16)Open the water supply line
17)After the gear motor starts, turn off the power supply. Remove the front panel, then move the control switch to the "DRAIN" position. Replace the front panel in its correct position.
18)Turn on the power supply and allow the water system to drain for 5 minutes. Note: If you do not sanitize the unit, go to step 14 in "III.A.5. Sanitizing
Procedure ‑ Final."
19)Turn off the power supply, then close the water supply line
38