Hoshizaki FD-1001MWH(-C), FD-1001MRH(-C) FD-1001MAH-C FD-1001MRH-C FD-1001MLH-C, Icemaker

Page 27

1. Icemaker

If you would like to convert to top water supply, install the optional Top Water Supply Kit (HS-2123).

Icemaker water supply inlet is 1/2" female pipe thread (FPT). A minimum of 3/8" OD copper tubing is recommended for the icemaker water supply line.

An icemaker water supply line shut-off valve and drain valve should be installed.

Icemaker drain outlet is 3/4" FPT. A minimum of 3/4" OD hard pipe is recommended for the icemaker drain line.

FD-1001MAH(-C) FD-1001MRH(-C) FD-1001MLH(-C)

To convert to top water supply, install the optional Top Water Supply Kit (HS-2123).

Icemaker

Icemaker Water

Supply Line

Shut-Off Valve

Icemaker Water

Supply Inlet

1/2" FPT

Separate piping to approved drain. Leave a 2-inch (5-cm) vertical air gap between the end of each pipe and the drain.

2-inch

(5cm) air gap

Icemaker Water

Icemaker

Supply Line

Drain Outlet

Drain Valve

3/4" FPT

 

 

Storage Bin

Bin Drain Outlet

 

3/4" FPT

 

Drain Floor

Fig. 14

27

Image 27
Contents Superior Degree Reliability Hoshizaki AMERICA, INC Contents Page Unit Important Safety InformationSerious injury Indicates important information about the use and careFD-1001MAH-C air-cooled Specifications Nameplate RatingFD-1001MWH-C water-cooled FD-1001MRH-C remote air-cooled FD-1001MLH-C low-side, parallel rack system Dimensions / Connections FD-1001MWH-C water-cooled FD-1001MRH-C remote air-cooled FD-1001MLH-C low side, parallel rack system See Fig II. Installation and Operating InstructionsChecks Before Installation How to Remove PanelsLocation SetupElectrical Connection For All ModelsAdditional Warnings for Remote Air-Cooled Model Installation of Remote Condenser Unit Checks Before InstallationLocation Line Set SetupField Fabricated Line Set Installation Polyol Ester POE OIL Electrical Connection Stacking Remote Condenser Units Connection to an R-404A Parallel Rack System Line Set InstallationRack System-Braze Connection Entire Male Fitting See , 15, or Water Supply and Drain ConnectionsIcemaker FD-1001MAH-C FD-1001MRH-C FD-1001MLH-CWater Supply FD-1001MWH-C CondenserConnection To a PotableFD-1001MWH-C Connection toClosed Loop Final Checklist Startup Infrared Sensor Check Bin Control CheckThumbscrew Infrared Sensor Housing Lens Mechanical Backup Bin Control Check Seconds 1.6 minutes Infrared Sensor Shutdown DelayCleaning Procedure III. Cleaning and MaintenanceCleaning and Sanitizing Instructions Cleaning SolutionFloat Switch Assembly Reservoir Cover Infrared Sensor Infrared Sensor Housing Lens Sanitizing Procedure Initial Sanitizing SolutionSanitizing Procedure Final Frequency Area Task MaintenancePreparing the Icemaker for Long Storage Remove the water from the icemaker water supply lineDrain the evaporator Page Hoshizaki AMERICA, INC