Hoshizaki KM-1300SRH-E Electrical Connection, Unpacking, Location, This Appliance Must be Earthed

Page 5

ENGLISH

Fig. 5

6. ELECTRICAL CONNECTION

WARNING

THIS APPLIANCE MUST BE EARTHED

This icemaker requires an earth that meets the na- tional and local electrical code requirements. To prevent possible severe electrical shock to individu- als or extensive damage to equipment, install a proper earth wire to the icemaker. Turn off the power supply before any maintenance, repairs or cleaning is undertaken.

•This icemaker must have a separate power supply or receptacle of proper capacity. See the Nameplate. It is recommended that this icemaker be the only electrical device on its power supply circuit.

•Stacked icemakers should each have a separate receptacle, but they must all be connected in parallel to the same single phase supply or circuit with sufficient ampacity.

•The opening for the power supply connection is

22.2mm. diameter to fit a conduit.

•If a power cord is used to provide electricity to the icemaker in place of the permanent (conduit) connection, a gland should be installed at the 22.2 mm. power supply connection. This gland should be of the correct size for the power supply cord being installed. The size of the conductors of this power supply cord should be suitable for the electrical consumption of this icemaker.

As the colours of the wires in the terminal box of this appliance may not correspond with field supplied wiring or with the markings identifying the terminals in your power supply receptacle, proceed as follows:

The wire which is coloured Green-and-Yellow must be connected to the terminal in the receptacle which is marked

with the letter E or by the symbol or coloured Green or Green-and-Yellow. The wire which is coloured Blue must be connected to the terminal which is marked with the letter “N” or coloured Black. The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red.

•Usually an electrical permit and services of a licensed electrician are required.

•For the electrical connection of the URC-12F-E remote condenser unit to the fan motor junction of the KM- 1300SRH-E, an IPX4 rated conduit is recommended. If a power supply cord is used, the cord itself should be certified for outdoor use and a gland rated IPX4 should be used where the cord enters the model URC-12F-E remote condenser.

•Usually an electrical permit and services of a licensed electrician are required.

7.INSTALLATION OF REMOTE CONDENSER UNIT (Remote Air-Cooled Model Only)

[a] UNPACKING

1)Unpack and remove shipping carton, tape(s) and packing.

2)Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the fan blade turns freely.

[b] LOCATION

The condenser unit is intended for outdoor use and must be positioned in a permanent, well ventilated site under the following guidelines:

•Select a firm and flat site.

•Should not be exposed to harsh or adverse weather conditions.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents KM-1300SAH-E KM-1300SRH-E Unpacking HOW to Remove Panels See FigLocation InstallationSee Stacking TWO IcemakersUnpacking Electrical ConnectionLocation This Appliance Must be EarthedInstallation Electrical Connection Water Supply and Drain Connections Stacking the Condenser UnitSee Fig KM-1300SAH-E KM-1300SRH-E Start UPBIN Control Check OperationHave all electrical and piping connections been made? Final Check ListAbnahme DER Platten Siehe Abbildung AuspackenAchtung VorsichtAbb a StandortAbb Abb b Stapeln VON Zwei Eismaschinen Siehe Bild 4Aufstellung StromanschlussAuspacken Installation Dieses Gerät Muss Geerdet Werden StromanschlussWarnung Stapeln VON KondensatorenWASSER- UND ABWASSER- Anschlüsse Vgl. Abb KM-1300SAH-E KM-1300SRH-E Abb II. Einschalten Betrieb Prüfung DER BehälterfüllstandsregelungCheckliste FÜR DIE Endüberprüfung Vea la figura DesembaladoCómo Retirar LOS Paneles Precaución UbicaciónInstalación Ver figuras 4 y Apilamiento DE DOS Dispensadores DE HieloAdvertencia Este Aparato SE Debe Conectar a Tierra Conexión EléctricaDesembalaje UbicaciónInstalación Precaución Este Aparato Debe Estar Conectado a Tierra Conexión EléctricaApilamiento DE LA Unidad DE Condensación Conexiones DE Suministro DE Agua Y DESAGÜE- Vea la figuraKM-1300SAH-E KM-1300SRH-E Arranque Inicial Comprobación DEL Control DEL Recipiente DE Almacenamiento OperaciónLista Final DE Comprobación Avertissement DeballageLE Demontage DES Panneaux Voir Figure Emplacement Voir Empilage DE Deux Distributeurs L’UN SUR L’AUTRERaccordements Electriques EmplacementAvertissement CET Appareil Doit Etre MIS a LA Terre DeballageInstallation Raccordements Electriques ’EAU ET DE LA Vidange Voir Figure Empilage DU CondenseurRaccordements DE L’ARRIVEE KM-1300SAH-E KM-1300SRH-E Mise EN Route Fonctionnement Verification DE LA Commande DE ReservoirCheck List Finale Rimozione DEI Pannelli V. FIG DisimballaggioAvvertenza AttenzioneUbicazione InstallazioneSovrapposizione Delle DUE Cubettatrici V. e Avvertenza Collegare IL Distributore a UNA Presa DI Terra Collegamenti ElettriciDisimballaggio PosizioneInstallazione Collegamenti Elettrici Collegamenti PER Alimentazione E Scarico Acqua Sovrapposizione DEL CondensatoreAvviamento Controllo Della Funzionalità Della Vaschetta FunzionamentoControlli finali HET Verwijderen VAN DE Panelen Zie Afb UitpakkenBelangrijk WaarschuwingAfb a InstallatieLocatie Afb b HET Stapelen VAN Twee IjsdispensersZie Plaatsen Elektrische AansluitingenUitpakken Hoshizaki Europe InstallatieElektrische Aansluitingen Afb Aansluitingen Voor Watertoevoer EN -AFVOER Zie Afb HET Stapelen VAN DE CondensorAfb Opstarten Werking Controle VAN DE BAKEindcontrole

KM-1300SRH-E, KM-1300SAH-E specifications

The Hoshizaki KM-1300SAH-E and KM-1300SRH-E are part of Hoshizaki's renowned line of ice makers, known for their reliability, efficiency, and high-quality ice production. These models are particularly well-suited for busy environments such as restaurants, cafes, and hotels where on-demand ice is essential for both food service and customer satisfaction.

One of the standout features of the KM-1300SAH-E and KM-1300SRH-E is their impressive ice production capacity. They can produce up to 1,300 pounds of crescent-shaped ice per day, ensuring that businesses can keep up with high demand without compromising on quality. The crescent ice produced by these machines is ideal for a variety of applications, including beverages, food display, and ice for culinary purposes.

Both models are equipped with the latest Hoshizaki technology, which includes a powerful refrigeration system that enhances energy efficiency and cooling speed. This advanced technology not only helps in maintaining optimal ice-making temperatures but also reduces energy consumption, making these machines more eco-friendly and cost-effective over time.

Another significant aspect of the KM-1300 series is the user-friendly design. The machines feature a built-in storage bin that holds up to 1,002 pounds of ice, allowing for ample storage capacity to meet peak demands. The front access design ensures easy maintenance and cleaning, which is crucial for keeping the ice machine operating smoothly and hygienically.

The KM-1300SAH-E and KM-1300SRH-E are also designed with durability in mind. Constructed with stainless steel, they offer resistance against corrosion and wear, ensuring a long lifespan in demanding environments. Their robust design allows them to withstand the rigors of daily use in commercial settings.

In terms of safety features, Hoshizaki has integrated several technologies into these models. The cleaning and sanitizing cycles are automated, reducing the labor involved in maintaining sanitary conditions. Additionally, the ice machines are equipped with a self-diagnosis feature that alerts users to any potential issues, allowing for quick troubleshooting.

In conclusion, the Hoshizaki KM-1300SAH-E and KM-1300SRH-E ice machines exemplify the brand's commitment to quality, efficiency, and innovation. With their substantial ice production capabilities, advanced features, and ease of maintenance, these models are a smart investment for any commercial establishment that requires reliable ice-making solutions. Adopting these machines can significantly enhance operational efficiency while ensuring that customers receive the best service possible.
Top Page Image Contents