Liebherr CS1660 manuel dutilisation Troubleshooting, Problem Possible Cause and Remedy

Page 24

Troubleshooting

If a problem occurs during operation, check whether it is due to an operating error.

Please note that even during the warranty period, some repair costs may be your responsibility. You may be able to correct the following faults by checking the possible causes yourself:

Problem

Possible Cause and Remedy

Appliance does not work,

- Is the appliance turned on properly?

display is off

- Is the power cord properly inserted in the outlet?

 

- Is the circuit breaker or fuse in operating condition?

The interior light does

- Is the refrigerator compartment turned on?

not come on

- Has the door been open for more than 15 minutes?

Loud running noise

- Is the appliance standing firmly on the floor, or does the compressor

 

cause nearby items of furniture or objects to vibrate? If necessary, move

 

the appliance slightly, align by adjusting the adjustable feet, or adjust

 

bottles and containers.

Motor seems to

- Is the ambient temperature too hot? See Safety Regulations.

run too long

- Has the appliance been opened too often or left open too long?

 

- A large amount of food has been added.

 

- Unit is in SuperCool mode. Verify unit is in normal operation mode.

The temperature is

- Is the temperature setting correct? See Setting the Temperature.

not cold enough

- Has an excessive amount of fresh food been placed in the appliance?

 

- Does a separately installed thermometer show the correct reading?

 

- Is the ventilation system working properly?

 

- Is the appliance set up too close to a heat source?

Freezer temperature display

The freezer temperature display will only show temperatures that are

shows two dashes - -

below freezing. When initially starting the freezer it will not be below freez-

 

ing. It will take three to five hours (depending on ambient conditions) for

 

freezing temperatures to be achieved and thus displayed numerically.

 

This may also occur after a power failure.

Ice or water drops appear

This is completely normal. During the cooling process, the humidity in the

on the rear wall in the inte-

refrigerator compartment will condense on the rear wall and freeze. During

rior of the refrigerator com-

the compressor idle period, the ice layer will defrost. The condensate on

partment.

the rear wall drains through the defrost water drain for evaporation.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Use and Care Manual Additional benefits Table of Contents Safety Electrical SafetyPlease read and follow these instructions Disposal of Old ApplianceImportant Safety Information Safety Regulations Disposal of CartonInstalling the Water Filter Water FilterWater Filter Figure Removing the Water FilterFeatures Description of Appliance and Equipment FigureDescription of refrigerator Description of freezerTemperature and control display Operating and Control Elements , FigureSetting the Temperature Figure To reduce the temperatureTo increase the temperature OperationTemperature Display Figure Audible Alarm Signal FigurePower Failure/FrostControl Ventilation FigureSetup Mode Figure How to activate the setup modeExit setup mode SuperCool Figure= Sabbath mode How to activate the Sabbath modeHow to deactivate the Sabbath mode = Display brightness How to adjust the display brightness= Temperature display mode How to change the temperature display to degrees CelsiusHow to adjust the water quantity = Water quantity for Ice cube tray= Drop symbol reset How to reset the drop symbolHow to activate the child lock How to deactivate the child lockRefrigerator Compartment Arranging Food Figure EquipmentRepositioning the door racks Figure Bottle grid FigureTo install the vegetable drawer Repositioning the shelves FigureIf you need space for large bottles and con- tainers Removing the shelves FigureInterior Light FreezingInformation System Figure Refrigerator Compartment Freezer CompartmentFreezer Compartment Freezing with SuperFrost FigureFreezing and Storage Safety Instructions and Warnings Ice MakerBleeding the Ice Maker To Start the Ice MakerHow to activate the Ice Maker Vacation State Ice Maker at VacationsCleaning CleaningDefrosting/Vacation DefrostingVacation Tips Troubleshooting Problem Possible Cause and RemedyIce Maker Troubleshooting Customer Service FigureService Number 2 and Appliance / Serial Number Appliance InformationWarranty LIEBHERR WARRANTY PLANManuel d’utilisation et d’entretien Avantages supplémentaires Table des matières Table des matièresSécurité Veuillez lire et suivre ces ins- tructionsÉvacuation de votre ancien appareil La sécurité et l’électricitéImportante information sur la sécurité Contraintes de sécurité Évacuation du cartonDu climat Protéger le revêtement du sol avant de déballer l’appareilInstallation du filtre à eau Filtre à eauFiltre à eau Figure Ôter le filtre à eau FigureCaractéristiques Description de l’appareil et de ses aménagements FigureDescription du réfrigérateur Description du congélateurÉléments de commande et de contrôle , Figure Ecran de température et de contrôleUtilisation Mise en marche et arrêt de l’appareilRéglage de la température Figure Pour diminuer la températureAlarme sonore- Figure Alarme porte ouverteAlarme élévation de température Affichage de température FigureMode Configuration Figure Comment activer le mode ConfigurationSortir du mode Configuration  = Mode du Sabbat Comment activer le mode du SabbatComment désactiver le mode du Sabbat La porte peut être ouverte et fermée en tout temps= Mode affichage de température = Quantité d’eau pour le bac à glaçonsComment régler la quantité d’eau = Fabrique à glaçons mode Vacances = Remise à zéro de l’icône GouttesComment remettre à zéro l’icône Gouttes = Sécurité enfantsCompartiment réfrigérateur Disposer les aliments Figure EquipementRepositionnement des Balconnets de porte Range-bouteillesRepositionner les étagères Figure Retirer les étagères FigurePour sortir le tiroir à légumes Pour mettre le tiroir à légumes en placeÉclairage intérieur CongélationSystème d’information Figure Compartiment congélateur Congeler avec SuperFrost Congélation et rangementRecommandations et consignes de sécurité Mise en service de la fabrique à glaçonsIceMaker Purge de la fabrique à glaçonsFabrique à glaçons en mode Vacances Nettoyage NettoyageDégivrage, Vacances DégivrageConseils pour les périodes de vacances Problème Cause possible et solution Recherche des pannesService à la clientèle Figure Recherche des pannes sur la fabrique à glaçonsInformation de l’appareil Problème Cause possible et remèdeGarantie Garantie LiebherrPara combinados frigorífico-congelador NoFrost con IceMaker Otros puntos a favor Índice ÍndiceSeguridad Por favor lea y siga estas ins- truccionesEliminación del aparato viejo Seguridad eléctricaInformación importante sobre la seguridad Generalidades Eliminación del embalajeLógico Filtro de agua Filtro de agua FiguraInstalación del filtro de agua Extracción del filtro de aguaDotación Descripción y dotación del aparato FiguraElementos de mando y control Elementos de mando y control Figura 6, FiguraPantalla de temperatura y control Funcionamiento Conexión/Desconexión delAjuste de temperatura Figura Bajar la temperatura frío más intensoIndicación de temperatura Figura 8 Ventilación Figura 8Avisador acústico Figura Indicación de corte de corriente eléctrica/FrostControlModo de configuración Figura Cómo activar el Modo de configuraciónSalir del Modo de configuración Función SuperCool Figura= Modo del Sábado Cómo activar el Modo del SábadoCómo desactivar el Modo del Sábado = Modo de indicación de temperatura Cómo cambiar la indicación de temperatura a grados Celsius= Cantidad de agua para la cubitera Cómo ajustar la cantidad de agua= Reset del símbolo de la gota = Estado de vacaciones del fabricador de hieloCómo hacer desaparecer el símbolo de la gota = Protección contra la manipulación por parte de niñosCompartimiento frigorífico Reparto de los alimentos Figura 11 DotaciónDesplazar los estantes Cara interior de puerta ¡Atención! Las tapas de las cajas tienen queDesplazar las baldas Figura Se puede conseguir más espacio para envases altosExtracción de las baldas Figura Extracción del cajón para fruta/verduraIluminación interior CongelaciónSistema de información Figura Compartimiento congelador Congelar con SuperFrost FiguraSugerencias para congelar y almacenar Advertencias generales y con- cernientes a la seguridad Purgado del fabricador de hieloPuesta en servicio Para encender el fabricador de hieloEl fabricador de hielo durante las vacaciones Limpieza LimpiezaDesescarche, Vacaciones DesescarcheConsejos para las vacaciones ¿Anomalías Problemas? Anomalía Posible causa y soluciónReglamentaciones de seguridad Ajuste de temperatura¿Anomalías Problemas en el fabricador de hielo? Servicio Técnico FiguraInformaciones sobre el aparato Garantía Plan DE Garantía LiebherrNotas For Service in the U.S Liebherr Service Center For Service in CanadaToll Free 1-866-LIEBHERR or

CS1660 specifications

The Liebherr CS1660 is a powerful and versatile crawler crane designed for heavy lifting in various construction and industrial applications. Renowned for its exceptional performance, the CS1660 has become a popular choice among contractors due to its advanced features and technologies.

One of the standout characteristics of the CS1660 is its impressive lifting capacity. With a maximum load capacity of 160 tons, this crane can handle a wide range of materials and equipment, making it suitable for tasks such as building construction, infrastructure development, and heavy machinery installation. The crane’s robust design and innovative engineering ensure stability and reliability, even when working on challenging job sites.

The Liebherr CS1660 is equipped with state-of-the-art hydraulic systems that provide powerful lifting capabilities and precise control. The crane features a multi-functional control system that allows operators to manage the machine’s movements seamlessly. This technology enhances operation efficiency, reducing the time required to complete complex lifting tasks. Additionally, the crane’s hydraulic components are designed for durability and low maintenance, ensuring that the CS1660 remains operational over extended periods.

Another key feature of the CS1660 is its modular design, which enables easy transport and setup. The crane can be disassembled into manageable components, allowing for convenient transportation to and from job sites. This modularity also means that the crane can be configured for various applications, providing flexibility for contractors who need to adapt to different project requirements.

The CS1660 also prioritizes operator safety and comfort. The cab is designed with ergonomic features, providing the operator with excellent visibility and easy access to controls. The advanced monitoring system provides real-time data on various operational parameters, enhancing safety and efficiency during lifting operations.

In summary, the Liebherr CS1660 crawler crane stands out for its powerful lifting capabilities, advanced hydraulic systems, modular design, and operator-friendly features. Its versatility makes it a valuable asset in the construction industry, ensuring that it can meet the demands of modern heavy lifting challenges while maintaining high safety standards.
Top Page Image Contents