Chapter 5 Error Message and Troubleshooting
2. Undo the screws (6 pcs.) to remove the front panel.
Only operate the unit with the cover panel attached.
The unit contains the power supply carrying high voltage inside that is isolated with the cover panel.
Only trained personnel are allowed to work, including unit inspection, around the power supply.
There is the presence of the surface in the unit that is at high temperatures during operation. Potential burns may occur if touched. Residual heat may cause burns despite the power being turned OFF. Be sure of the surface reaching room temperature before work.
The unit contains a section which rotates when it is in action. Potential personal injury may occur if touched. A rotator is structured to come to a temporary stop and resume rotation.
Avoid performing work during system operation.
Screw
Electrical unit
Screw
Front panel
Front
Fig. 5-3 Removal of Front Panel
5.3 Alarm Reset (Alarm Lamp OFF) | |
1st edition : Aug. 2006 | |
Rev. A: May. 2007 |