Aiwa AV-X220 manual Setting the Clock, Setting the Sleep Timer, Press the SET button

SETTING THE CLOCK

CLOCK

1,3,5

2,4

When the AC cord is connected for the first time, the clock on the display flashes.

Set the time as follows while the power is off.

1 Press the SET button.

The hour flashes.

2 Press the DOWNY or UPA button to designate the hour.

3Press the SET button to set the hour.

The hour stops flashing and the minute starts flashing.

4Press the DOWNV or UPA button to designate the minute.

5Press the SET button to set the minute.

The minute stops flashing on the display and the clock starts from 00 second.

To correct the current time

Press the POWER button to turn the unit off. Press the SET button and carry out steps 1 to 5 above.

To display the current time

Press the CLOCK button on the remote control. The clock is displayed for 4 seconds.

To switch to the 24-hour standard

Press the POWER button while pressing the UPA or DOWNY button while the current time is displayed.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes while the power is off

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

SETTING THE SLEEP TIMER

f~ --+

G 0000

000

000

—2

00

Ja)oo=

1

00

3

.=,

The receiver can be automatically turned off at a specified time.

Use the remote control.

1 Press the AIWA RECEIVER button.

2 Press the SLEEP button.

3 Press the UP- or DOWN- button within

four seconds to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps.

Specified time

To check the time remaining until the power is turned off Press the SLEEP button once. The remaining time is displayed

for four seconds.

To cancel the sleep timer

Press the SLEEP button twice so that “SLEEP on the display disappears.

15 ENGLISH