Aiwa AV-X220 manual Before Operation, If the receiver cannot be operated with the remote control

FUNCTION button

Each time this button is pressed, the sound source changes

FM (or AM)’) ~V3~V2~Vl~CD~AUX~PHONO cyclically.

al:Either band, which you have tuned in fOrthe laSttime, ComesOn.

TUNER PRESET buttons

Tune in the station which has been preset on the receiver.

To go to a higher preset number, press the UPM button. To go to a lower preset number, press the DOWN H button.

BEFORE OPERATION

TAPE MONITOR

POWER [ FUNCTION buttons VOLUME

mH

It is not necessary to press the AIWA RECEIVER button each time you operate the Aiwa receiver unless another mode has already been set. (See “REMOTECONTROL” on page 14.)

If the receiver cannot be operated with the remote control

Follow the steps below with the remote control.

1 Press the AIWA RECEIVER button.

2 Press and hold the SET UP button for about 2.5 seconds.

The indicator on the top of the remote control blinks twice while pressing the button.

3 Press the DIGIT buttons in the order of “4,” “O” and “6.”

PHONES FRONi SPEAKERS A, B

To turn the unit on

1 Turn the VOLUME control toward MIN.

Otherwise, the speakers may be damaged.

2 Press one of the FUNCTION buttons (TUNER, PHONO, AUX/TV, CD, VIDEO 1, VIDEO 2 or VIDEO 3) or the TAPE MONITOR button.

When pressing the TUNER button, the previously tuned station is received (Direct Play Function).

The POWER button is also available. Operation is possible after four seconds.

To select the front speaker system

To use speaker system A: Set the FRONT SPEAKERS A button

to sON.❑ To use speaker system B: Set the FRONT SPEAKERS B button

to sON.

To use both speaker systems : Set both the buttons to ~ ON. Set the button(s) to 10FF to turn off the speaker system(s).

m

As the front speaker systems A and B are connected in series:

-The sound will be slightly decreased when using both speaker systems

-No sound can be heard if the FRONT SPEAKERS A and B buttons are set to ~ ON when only one speaker system is connected

To change a displayed nalme for the AUX/TV button and

VIDEO 2 button

When the AUX/TV button is pressed, AUX is displayed initially. It can be changed to TV.

With the power on, press the POWER button while pressing the AUX/TV button,

The displayed name for VIDEO 2 button can be changed to VIDEO 2, LD or MD; with the power on, press the POWER button while pressing the VIDEO 2 button.

Using the headphones

Connect headphones to the PHONES jack with a standard stereo plug (06.3 mm, 1/4 inch). Be sure to set the FRONT SPEAKERS A and B buttons to 10FF. Otherwise sound is output from the speakers.

m

When using the headphones, set the Dolby Pro Logic and DSP system to off.

To turn the unit off

Press the POWER button.

ENGLISH 6