Aiwa XR-M1000 manual Turn Multi JOG to designate the minute, then press Enter, Press Sleep

1 2,3 1,2J3

1 Press CLOCWTIMER m, then press ENTER within 6 seconds.

2 Turn MULTI JOG to designate the hour, then press

ENTER.

The hour stops flashing and the minute starts flashing.

3 Turn MULTI JOG to designate the minute, then press ENTER.

The minute stops flashing on the display and the clock starts from 00 seconds.

To switch to the 24-hour standard

Press the CLOCWTIMER and then press MULTI JOG within 6 seconds.

Repeat the same procedure to restore the 12-hour standard.

‘?5

The unit can be turned off automatically at a specified time.

Use the remote control.

1 Press SLEEP.

“SL~EP”appears.

2 Within 4 seconds, press ++ or * to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps.

If the clock display flashes

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

●CLOCK on the remote control is also available instead of CLOCK7 TIMER.

●IISET on the remote control is also available instead of ENTER.

●44 or W on the remote control is also available instead of MULTI JOG.

To check the time remaining until the power is turned off

Press SLEEP W. The remaining time is displayed for 4 seconds.

To cancel the sleep timer Em

Press SLEEP ME so that “SLEEP on the display disappears.

ENGLISIY 13