Aiwa XR-M1000 manual Inserting Blank Spaces, Insert the tape to be recorded on into deck

This section explains how to record from the tuner, CD player, or external equipment.

1

I

		1
7—.		i
	‘.	.—z-—-i
1 —-----

@@

3“ 2 !i I; PAUSE &OP

Preparation

●Use Type I (normal) and Type II (high/CrOz) tapes for recording.

●Set the tape to the point where recording will start.

..... ... ..

INSERTING BLANK SPACES

Insertion of 4-second blank spaces enables you to activate the

Music Sensor function.

1 Press ● REC/REC MUTE during recording or while in recording pause mode.

The indicator on the 6 REC/REC MUTE flashes for 4 seconds and the tape runs with no sound recording. After 4 seconds, the deck enters the recording pause mode.

2Press II PAUSE to resume recording.

To insert a blank space of less than 4 seconds, press ● REC/REC MUTE again while the indicator on ● REC/REC MUTE

is flashing,

To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press ● REC/REC MUTE again. Each time the button is pressed, a 4-second blank space is

added.

7 Insert the tape to be recorded on into deck 2.

Insert the tape with the side to be recorded on first facing out

from the unit.

EJECT

I I IJ

2 Press REV MODE to select the reverse mode.

To record on one side only, select Z.

To record on both sides, select =) or C=).

3 Press DOLBY NR to turn Dolby NR on or off.

To record with DOLBY NR, turn on no NR,

To record without DOLBY NR, turn off DO NR.

4 Press function on the stereo receiver (CD, TUNER, VIDEO/AUX or MD) and prepare the source to be recorded.

To record from a CD, press CD and load the disc(s).

To record from a radio broadcast, press TUNER and tune

in to a station.

To record from a connected source, press VIDEOIAUX or

MD.

5 Press ● REC/REC MUTE to start recording.

When the selected function is CD, playback and re;ording start simultaneously.

TO stop recording, press ■ STOP (or H CLEAR on the remote

control).

To pause recording, press II PAUSE (or I I SET on the remote control). To resume recording, press it again.

Sound adjustment during recording

The output volume and tone (except BBE and Rhythm play function) of the speakers or headphones may be freely varied without affecting the recording.

26 ENGLISH

About cassette tapes

●To prevent accidental erasure, break off the plastic tabs on the cassette tape with a screwdriver or other pointed tool after recording.

Type II tapeTab for side A

1

detection

slot

To record on the tape again, cover the tab openings with adhesive tape, etc. (On Type II tapes, take care not to cover the Type II tape detection slot,)

●120-minuteor longer tapes are extremely thin and easily deformed or damaged. They are not recommended.

●Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam in the mechanism.

DOLBY NR system

The Dolby Noise Reduction system reduces tape hiss noise,

For optimum performance when playing back a tape recorded with the DOLBY NR system, turn on the DOLBY NR system.