Aiwa XR-M1000 manual Press REC/REC Mute to start recording on, First Side

		6 Press ● REC/REC MUTE to start recording on the
		first		side.
		The tape is rewound to the beginning of the front side, the
	■STOP I	lead segment is played through for 10 seconds, and recording
4		starts. When recording on the front (side A) ends, recording
		on	the	back (side	B) starts.
		To stop		recording
		Press	■ STOP on		the cassette deck or on the CD player (or

■CLEAR on the remote control). Recording and CD play stop simultaneously.

To clear the edit program

Press WSTOP W on the CD player (or ■ CLEAR W on the remote control) in stop mode so that the highlighted indicator “EDIT” on the display disappears.

The Al edit recording function enables CD recording without worrying about tape length and track length. When a CD is inserted, the unit automatically calculates the total track length. If necessary, the order of tracks is rearranged so that no track is cut short.

(Al: Artificial Intelligence)

To check the order of the programmed track numbers Before recording, press EDIT/CHECK on the remote control to

select a side, and press + or ➤P on the CD player repeatedly.

Track number Programmed track numbers

Program number

m

Al edit recording will not start from a point halfway into the tape. The tape must be recorded from the beginning of either side.

7 Insert the tape into deck 2, and press DOLBY NR to turn Dolby NR on or off.

Insert the tape with the side to be recorded on first facing out

from the unit.

2 Press CD on the stereo receiver and load the disc(s).

3 Press EDiT/CHECK on the remote control once.

“EDIT” and “AI”are highlighted.

Al EDIT

II

●When “PRGM” is highlighted, press EDIT/CHECK again.

4 Press DISC DIRECT PLAY 1-3 to select a disc.

5 Press numbered buttons O-9 on the remote control to designate the tape length.

10 to 99 minutes can be specified.

Example: When using-a 60-minute tape, press 6 and O.

In a few seconds, the tracks to be recorded on each side of the tape are determined.

●<, * is also available to designate the tape length.

	Remaining time	Programmed
Ta~e length	of recordi;g	tracks for side A
	1	I

Tape side

a:First recording side (side A)

b:Second recording side (side

B)

To add tracks from other discs to the edit program

If there is any time remaining on the tape after step 5, you can add tracks from other discs in the CD compartment

1 Press EDIT/CHECK on the remote control to select a side.

2Press DISC DIRECT PLAY 1-3to select a disc,

3Press the numbered buttons on the remote control to select tracks.

A track whose playing time is longer than the remaining time cannot be programmed.

4Repeat steps 2 and 3 to add more tracks.

Time on cassette tapes and editing time

The actual cassette recording time is usually a little longer than the specified recording time printed on the label. This unit can program tracks to use the extra time. When the total recording time is a little longer than the tape’s specified recording time after editing, the display shows the extra time (without a minus mark), instead of the time remaining on the tape (with the minus mark).

m

●The Al edit recording function cannot be used with discs containing 31 tracks or more.

●Recording is inhibited if the erasure prevention tab on either side of the tape is broken off.

28 ENGLISH