Whirlpool 4322452 manual Voltage Checks

Electrical Shock Hazard

Disconnect the gas range’s line cord plug from the wall receptacle before you service any of the components inside the unit. Failure to do this could result in violent electrical shock.

VOLTAGE CHECKS

When making voltage checks, be sure to observe the following precautions:

1.The floor must be dry. Water and dampness increase the chances of electrical shock.

2.Set the voltmeter correctly for the voltage being measured.

3.Touch only the insulated parts of the meter probes.

4.Touch the component terminals, or wires, with the meter probe tips only.

5.Touch the meter probe tips only on the terminals being checked. Touching other components could damage good parts.

PARTS QUALITY

An important step in the appliance repair procedure is the selection of FSP® (FACTORY SPECIFICATION PARTS) as replacements. Use of “fits-all,” or “look alike” parts could result in early parts failure, safety hazard, or substandard perfor- mance of a WHIRLPOOL appliance. It could also result in an unnecessary repeat of your repair efforts.

To be sure that the part(s) you purchase meet the exacting quality standards used to build every new WHIRLPOOL appliance, be sure to ask for genuine FSP replacement parts, as specified for your model. “FSP” is a registered trademark of WHIRLPOOL CORPORATION.

You can buy your genuine FSP replacement parts from any authorized WHIRLPOOL Parts Distributor.

WHIRLPOOL CORPORATION assumes no responsibility for any repair made on our products by anyone other than qualified TECH-CARE®Service Technicians.

Copyright 1998 Whirlpool Corporation, Benton Harbor, MI

ii