Garland MP-GS, MP-GD-10-S service manual Open Base Assembly, Inner Outer

Open Base Assembly

Use the following sequence of steps to assemble and install the open base accessory..

1.(See Figure 2..).. Align the rack guide upper support to the corresponding holes in the oven base.. Fasten using three #10 x 3/4” machine screws on each side of the oven..

2.At the lower end of each leg install an “L” shaped support clip using a #10 x 3/4” sheet metal screw.. Do this before fastening the leg to the base..

3.Install legs to the bolt holes at the front and rear of the base on the oven’s left side, (side lying on the floor).. If installing casters, be sure to install a locking caster on the front leg.. Refer to the section, “Legs and Casters,” on the previous page for installation details..

4.Fasten the open base panel in place on the brackets of the two legs already installed, using one #10 x 3/4” sheet metal screw in each corner..

5.While supporting the open base panel, install the right- side legs as in step 2.. Ensure the caster with a brake is at the front of the oven.. Fasten the remaining two corners of the open base panel to the other two legs just installed..

6.Carefully return the oven to an upright position.. Ensure the two legs/casters that touch the floor first when you raise the oven are blocked and chocked so they do not slip away..

7.Install the rack guides in one of the two available positions.. The inner position sets the guides at a width to accommodate oven pans.. The outer position sets the guides at a width to accommodate wire oven racks.. To attach, insert the longer straight end at the top of the rack guide all the way into the mounting hole, then align the bottom holes and lower the rack guide into position..

8.It is very important to use the adjustable bullet foot inserts in leveling the unit.

9.If you have installed casters, be sure to install the restraint bracket on the lower left corner of the rear of the oven using two #10 x 3/4” sheet metal screws..

SCRREW (2 EACH CLIP) SCREW (1 EACH CLIP)

OPEN BASE UPPORT CLIP (4)

LEG ASSEMBLY (4)

W/FOOT INSERT

INNER

OUTER

INNER GUIDE POSITION

FOR TRAYS

Figure 2.