Sherwood R-965 manual Setting the System Setup, When selecting the Digital Input Setup

ENGLISH

SETTING THE SYSTEM SETUP

S Y S T E M					S E T U P					To assign the connected DIGITAL INs to the desired input sources respectively
										To adjust the tone as desired or to select the desired cinema EQ mode.
D I G I T A L		I N P U T S E T U P
TO NE C O N T R O L										To set the OSD AUTO DISPLAY mode as desired .
OS D A U T O D I S P L A Y :									On
										To select a video input source
C UR R E N T		V I D EO :				VID 1
C OMP O N E N T			V I D E O				S E T U P			To assign the connected COMPONENT VIDEO INs to the desired of VIDEO 1~6.
V I D E O 2		OU T :			Off
D C	T R I G G ER 2			S E T U P						To set the VIDEO 2 OUT mode as desired.
D .	R E - M A S T E R I N G :							Off		To select the desired input source that uses the DC trigger 2 function.
R E T U RN : B a c k E N T E R : S e l e c t
										To select the desired digital re-mastering mode.
D .	R E - M A S T E R I N G :
								Off		To adjust the A/V SYNC as desired.
A / V	S Y N C :		0 F r a m e
R E T U RN : B a c k					, : S e l e c t

Note:

•When the pure audio function is activated, the TONE CONTROL cannot be selected.

When selecting the DIGITAL INPUT SETUP

•You should assign the connected DIGITAL INs to the desired of CD, AUX and VIDEO 1~6. (For details, refer to “CONNECTING DIGITAL INs and OUTs” on page 8.)

Press the CURSOR UP()/DOWN( ) buttons to select the DIGITAL INPUT SETUP, then press the

1 ENTER button.

PAGE	MAIN	FAV
VOL

1 2 3

4 5 6

7 8 9

0

D I G I T A L I N P U T S E T U P

C D	:	COAX1
A UX	:	U S B
V I D E O 1	:	OPT1
V I D E O 2	:	OPT2
V I D E O 3	:	OPT3
V I D E O 4	:	COAX2
V I D E O 5	:	OPT4
V I D E O 6	:	OPT5
R E T U R N : B a c k		, : S e l e c t

MI M2 M3

2	Press the CURSOR UP( )/DOWN( )
	buttons to select the desired input source.
	PAGE MAIN FAV
	VOL

1 2 3

4 5 6

7 8 9

0

MI M2 M3

•Each time these buttons are pressed, “” and “ ” are moved to the corresponding DIGITAL IN.

Repeat the above steps and until the

4 connected DIGITAL INs are assigned to the desired input sources respectively.

3	Press the CURSOR LEFT( )/RIGHT( )
	buttons to select the desired DIGITAL IN.
	PAGE MAIN FAV
	VOL

1 2 3

4 5 6

7 8 9

0

MI M2 M3

•Each time these buttons are pressed, the DIGITAL INs change.

Notes:

•When you select “None” instead of a DIGITAL IN for an input source, the analog input is automatically selected.

•In such a case that a DIGITAL IN is assigned to two input sources or more, when these input sources are selected, the digital audio signals can be heard from

the same DIGITAL IN.

53