Sherwood R-965 manual Component video input default settings

ENGLISH

VIDEO 1 Video deck, DVD recorder, etc.

YCOMPONENT CB OUT

CR	AUDIO		AUDIO		(COMPOSITE)		S-VIDEO
		OUT		IN		VIDEO	OUT IN
	R L		R L		OUT IN

VIDEO 2 DVD player, DVD recorder, etc.

YCOMPONENT CB OUT

CR	AUDIO		AUDIO		(COMPOSITE)		S-VIDEO
		OUT		IN		VIDEO	OUT IN
	R L		R L		OUT IN

•The jacks of VIDEO 1 / VIDEO 2 may also be connected to a DVD recorder or other digital video recording component. For details , refer to the operating instructions of the component to be connected.

•For ROOM 2 playback, the VIDEO 2 / ROOM 2 OUT jacks can be connected to the amplifier, TV , etc. installed in another room. (For details , refer to “ROOM 2 connections” on page 12.)

VIDEO 3 DVD player, LD player, Video deck, etc. MONITOR TV, Projector, etc.

Y	COMPONENT				Y	COMPONENT
CB	OUT				CB	IN
CR	AUDIO		(COMPOSITE)	S-VIDEO	CR	(COMPOSITE)	S-VIDEO
	OUT		VIDEO	OUT		VIDEO	IN
	R	L	OUT			IN

•The jacks of VIDEO 3 / VIDEO 4 / VIDEO 5 can also be connected to an additional video component such as a cable TV tuner, an LD player or satellite system .

•Connect the jacks of VIDEO 4 / VIDEO 5 to the video components in the same way.

Component video input default settings : (*)

•If you connect the COMPONENT VIDEO INs to your video components, it is easier to do so following the default settings.

•If your component video connections are different from the default setting , you should assign the COMPONENT VIDEO INs you used with the “When selecting the COMPONENT VIDEO SETUP” procedure on page 56.

•The default settings are as follows :

COMPONENT IN 1 : VIDEO 1, COMPONENT IN 2 : VIDEO 2, COMPONENT IN 3 : VIDEO 3

7