GE JGBS09, JGBS10 manual Installing the ANTI-TIP Device, When ALL Hookups are Completed

Page 38

Installation Instructions

10INSTALLING THE ANTI-TIP DEVICE

WARNING!

•Range must be secured with an approved Anti-Tip device.

•Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.

•After installing the Anti-Tip device, verify that it is in place by carefully attempting to tilt the range forward.

•This range has been designed to meet all recognized industry tip standards for all normal conditions.

•The use of this device does not preclude tipping of the range when not properly installed.

•If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

AMark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

Anti-Tip

device

Slotted head

10INSTALLING THE ANTI-TIP DEVICE (CONT.)

Wallboard

Back of range

Anti-Tip

 

device

 

Wood screw

 

Install the sleeve anchor into the drilled hole and then install the lag bolt through the device. The bolt must be properly tightened as recommended for the hardware.

ESlide the range against the wall, and check for proper installation by grasping the front edge of the cooktop and carefully attempting to tilt the range forward.

WHEN ALL HOOKUPS ARE

COMPLETED

Make sure all controls are left in the off position. Make sure the flow of combustion and ventilation air to the range is unobstructed.

screw

Approx. 20°

Wallplate

CONVERTING TO LP GAS (or converting back to natural gas from LP)

2 1⁄8” Marked edge of range

BLocate the outside edge of the device 21⁄8 ″ toward the center of the range from the marked edge of the range.

CUsing the device as a template, mark the position of the hole for the screw.

DFor wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available.

Mount the Anti-Tip device with the screw provided.

For cement or concrete construction, you will need a 1/4″ x 11⁄2″ lag bolt and a 1/2″ O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be performed by a qualified LP gas installer.

The conversion instructions and LP orifices can be found attached to the range next to the pressure regulator.

Keep these instructions and the orifices in case you want to convert back to natural gas.

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Write the model and serial numbers here Serial #ANTI-TIP Device All ranges can tip and injury could resultImportant Safety Notice Instructions Cook Meat and Poultry THOROUGHLY… Surface Burners Troubleshooting Tips Consumer Support Operating Instructions Installation InstructionsFeatures of your range Instructions Installation Instructions Instructions OperatingInstructions Using the gas surface burnersTips Installation Top-of-Range Cookware SafetyCase of Power Failure Stove Top GrillsHow to Insert the Griddle Using the griddleSafety Instructions Using the GriddleOven Control Using the ovenTo Set the Clock on some models Control knobConsumer Support Installation Tips Consumer SupportConsumer Support Troubleshooting Tips Using Aluminum FoilBroiling Guide Instructions Operating InstructionsType of margarine will affect baking performance Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat Range and look at the back sideGriddle Care and cleaning of the rangeGriddle Precautions Burner Assemblies Burner Caps and Heads ReplacementAfter cleaning Burner capsTo replace the grates Burner GratesCooktop Surface Lift-Off Oven Door To clean the inside of the doorTo clean the outside of the door Oven BottomRemovable Kick Panel on some models Oven Light ReplacementBroiler Compartment on some models Oven ShelvesPorcelain Oven Interior Oven Air VentsLower Control Panel Front Manifold Panel and Knobs Installation Instructions Range Before YOU BeginPart Included For Your SafetyTools YOU will Need Materials YOU MAY NeedLess than 24 Inches Dimensions and Clearances Range may be placed with 0″ clearance flush at the back wallLocation Model and Serial Number LocationConnect the Range to GAS 10″ of water columnGAS Pipe and Electrical Outlet Locations Flexible Connector Hookup Rigid Pipe HookupGrounding IMPORTANT-Please read carefully Electrical ConnectionsExtension Cord Cautions Electric Disconnect Seal the OpeningsAssemble Surface Burners Electric Ignition Models Check Ignition of Surface BurnersCheck Ignition of Oven Burner Quality of FlamesLeveling the Range To remove the oven bottomInstalling the ANTI-TIP Device When ALL Hookups are CompletedBefore you call for service… Problem Possible Causes What To DoPower outage See the Installation of the range sectionOven temperature Food does notWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration What GE Will Not Cover GE Gas Range WarrantyGE Will Replace Warrantor General Electric Company. Louisville, KYConsumer Support GE Appliances Website Schedule ServiceParts and Accessories Real Life Design StudioManual del propietario e instrucciones de instalación Modelo No Serie NoTodas las estufas se pueden voltear y puede causar lesiones Lea todas las instrucciones antes de usar este aparatoOperación Instrucciones de Instalación Solucionar problemas OperaciónSolucionar problemas Cocine LA Carne Y EL Pollo Completamente Quemadores Instrucciones de InstalaciónSolucionar ProblemasSoporte al consumidor Características de la estufa SeguridadSoporte al consumidor Soporte al consumidor Solucionar problemasCómo cocinar en el quemador a gas Cómo elegir el tamaño de la llamaBatería de cocina para la estufa SoporteAl consumidor Parrilla para la superficie de la estufaCómo insertar la plancha para asar Plancha para asarCómo usar la plancha Control del horno Para configurar el reloj en algunos modelosCómo usar el horno Cortes de energía Antes de comenzar…Ventilación del horno Luz del hornoHumedad del horno Cómo ajustar el horno para hornear o para asarEnvoltura de aluminio Tipo de comidaAsado a la parrilla en algunos modelos Uso del papel aluminioGuía para asar a la parrilla Minutos ComentariosPara ajustar el termostato Ajuste del termostato del horno-¡hágalo usted mismoEl tipo de margarina afecta el desempeño del horneado Precauciones con la plancha Cuidado y limpiezaPlancha para asar Precaución No opere Ensambladuras del quemadorCabezas del quemador Tapas y cabezas del quemadorTapas del quemador ReemplazoPara reemplazar las rejillas Rejillas de los quemadoresSuperficie de la estufa Puerta del horno de levantar SolucionarproblemasPrecaución No limpie la Fondo del hornoPanel inferior removible en algunos modelos Precaución Antes deCompartimiento para asar a la parrilla en algunos modelos Estantes del hornoConductos de ventilación del horno Interior de porcelana del hornoAntes DE Comenzar Lea estas instrucciones completa y cuidadosamenteParte Incluida POR SU SeguridadMateriales QUE Puede Necesitar Si percibe un olor a gasAdvertencia Instrucciones DE Seguridad DE Instalación Protegidos Nunca Debe SER Menor DE 24″ 61 cmDimensiones Y Tolerancias 45.7 cmImportante LocalizaciónLocalización Modelo Y Número DE Serie Conecte EL Suministro DE GAS Adecuado Conecte LA Estufa AL GASInstrucciones de instalación Conector Flexible Conexiones a LA Tubería RígidaConexiones Eléctricas Precauciones con los cables de extensiónQuemador sin antes colocar todas las partes Selle LAS AberturasDesconexión eléctrica Modelos con ignición eléctrica Revisar Ignición DE Quemadores DE LA SuperficieRevise LA Ignición DEL Quemador DEL Horno Calidad de la llamaPara retirar el fondo del horno NecesarioNivelación DE LA Estufa Advertencia Cuando Toda LA Instalación Esté CompletaProblema Causas posibles Qué hacer Antes de llamar para solicitar servicio…Seguridad Operación Instrucciones de Instalación Notas Seguridad OperaciónNotas Lo que no está cubierto por GE Garantía de GE para su estufa a gasGE reemplazará Garante General Electric Company. Louisville, KYGarantías ampliadas Soporte al Consumidor Página Web de GE AppliancesSolicite una reparación Piezas y accesorios
Top Page Image Contents