Disassembly Procedures
!WARNING
To avoid risk of electrical shock, personal injury, or death: disconnect electrical and gas supply before servicing.
Open Burner
1.Remove maintop assembly, see "Maintop Assembly" procedure, steps 1, 4 and 5.
2.Remove clip securing burner tubing to surface valve.
3.Lift surface burner and gently move burner up and toward the rear of the range.
4.Replace and reassemble in reverse order.
Oven Sensor
1.Disconnect power before servicing.
2.Open oven door and remove screws securing sensor to oven cavity.
NOTE: Gently pull wiring through cavity wall.
3.Disconnect oven sensor at the connector terminal and remove.
4.Reverse procedure to reinstall sensor.
NOTE: Verify connection is pushed through the insulation.
Bake Burner and Ignitor
1.Turn off electrical power and gas to the range.
2.Disconnect gas and power from unit.
3.Remove oven door and racks.
4.Remove screws securing bottom bake cover.
5.Raise the back of the bake burner cover and slide cover back to release the front edge of cover and lift out of oven cavity.
6.Remove screws securing bake burner assembly to the oven chassis.
7.Maneuver bake burner from the burner orifice and out of the slotted location.
8.Pull forward on assembly to allow the ignitor terminal plug to pass through the back of the oven cavity.
9.Disconnect terminal plug and remove assembly from the oven cavity.
10.Remove screws securing ignitor to bake burner.
11.Replace and reassemble in reverse order.
Broil Burner and Ignitor
1.Turn off electrical power and gas to the range.
2.Disconnect gas and power from unit.
3.Remove oven door, and racks.
4.Remove screws securing ignitor wire plate cover to back of the oven cavity.
5.Maneuver ignitor wire terminal plug through the rear of the oven cavity.
6.Disconnect ignitor wire terminal plug.
7.Remove screws securing broiler to oven cavity.
8.Carefully maneuver burner off of the broiler orifice spud and remove from cavity.
9.Remove screws securing ignitor to broiler.
10.Remove wing nut securing flame spreader to broiler.
11.Replace and reassemble in reverse order.
Valve / Regulator Assembly
NOTE: Requires removal of range from installation position.
1.Turn off electrical power and gas to the range.
2.Disconnect gas and power from unit.
3.Remove nut securing broiler tubing to gas valve.
4.Remove nut securing bake tubing to gas valve.
5.Remove screws securing assembly to unit chassis.
6.Disconnect wires and gas lines to gas valve.
7.Replace and reassemble in reverse order.
Manual Oven Door Latch Assembly
1.Remove maintop assembly, see "Maintop Assembly" procedure, steps 1 through 6.
2.Remove screws securing latch assembly to the front of the oven cavity outer shell.
3.Label and disconnect wire terminals from latch assembly.
4.Reverse procedure to reinstall door latch assembly.
Spark Module
NOTE: Requires removal of range from installation position.
1.Remove screws securing lower rear access panel.
2.Disconnect and label wire connections from the spark module.
3.Remove screws securing spark module to unit chassis.
4.Replace and reverse procedure to reassemble.
Oven Door Removal
!WARNING
To avoid risk of personal injury or property damage, do not lift oven door by the handle.
1.Open oven door and place door hinge locking device into lock position.
2.Place oven door in first stop position, then grasp both sides and lift up off the hinges.
3.Reverse procedure to reinstall oven door.
©2004 Maytag Services | 16023522 | 21 |