Conversion Instructions (Models AGR5712AD*, CG34800AD*, CGR3725AD*, MGR5751AD*, MGR5752AD*, PGR5720LD*)
4. Remove the surface burner orifice hood with a (12.7
mm)socket wrench
:Save all natural orifice hoods that are
removed.
5.Place the corresponding orifice hood on the burner fitting according to figure 6. Turn the orifice hood clockwise by hand approximately one turn. Tighten the
orifice hood clockwise with a socket wrench approximately 2 turns.
6.Replace the burner assembly in the main top and rotate
7.Repeat steps 3 through 6 until all orifice hoods have been changed.
7.2K BTU NATURAL (BLUE) | 9.2K BTU NATURAL (NO COLOR) |
REPLACE WITH ORIFICE (BLUE) | REPLACE WITH ORIFICE (NO COLOR) |
STAMPED .0310 FOR LP | STAMPED .0335 FOR LP |
9.2K BTU NATURAL (NO COLOR) | 12K BTU NATURAL (RED) | |
REPLACE WITH ORIFICE (RED) | ||
REPLACE WITH ORIFICE (NO COLOR) | ||
STAMPED .0335 FOR LP | STAMPED .0350 FOR LP |
a. The approximate length of the flame of oven burner is a 1/2 inch distinct inner blue flame, figure 8.
b. Oven burner flame can be checked as follows:
1.Yellow flame on burner - open burner air shutter to the widest opening that will not cause the flame to lift or blow off the burner when cold. (See #2 on figure 9.)
2.Distinct blue flame but lifting - close burner air shutter to the point where it will not cause the flame to lift or blow off the burner when cold. (See #2 on figure 9.)
3
LOCK
SCREW
AIR SHUTTER
FRONT OF MAINTOP |
| ART. |
|
|
|
1
2
ORIFICE
HOOD
Replace burner assembly in main top and rotate approximately
ORIFICE HOOD
c.The oven burner air shutter adjustment is the same on ranges with a gas pilot or electric ignition.
d.Sealed burner adjustment. Adjust the air shutter for the appropriate gas according to figure 10.
AIR SHUTTER NATURAL POSITION
AIR SHUTTER
LP POSITION
©2004 Maytag Services | 16023522 |