Maytag AGR4400ADW, CPL1100ADH/L/Q/T/W, AGR5712ADB/Q/S/W, CG31400ADW Seconds of powering up the unit

Component Testing Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas.

Illustration	Component	Test Procedure	Results
M1 Controlled	Oven temperature	Press Bake pad.	While increasing or decreasing oven
	adjustment	Enter 550 on the digit-pad.	temperature, this does not affect self-
		Immediately press and hold Bake pad	cleaning temperature.
		for 3 to 5 seconds.
		Oven can be adjusted from -35 to +35
		degrees in 5-degree increments by
		pressing More + or Less - pads. To
		avoid over adjusting the oven, move
		temperature 5 degrees each time.
		Wait 4 seconds for the data entry
		timer to expire to accept the change.
		Temperature adjustment is retained
		even through a power failure.
M1 Controlled	Temperature display	Press and hold Cancel and Bake	This mode enables the user to indicate
		pads for 3 to 5 seconds. Press	°F or °C on the display.
		More + or Less - pads to change.
M1 Controlled	Clock Display	Press and hold Cancel and Clock	Allows clock to be toggled On or OFF.
		pads for 3 to 5 seconds.
M1 Controlled	24 Hour Clock	Press and hold Cancel and Delay	Allows the time on the clock to be
		pads for 3 to 5 seconds. Press	toggled from 12 hour or 24 hour display.
		More + or Less - pads to change.
M1 Controlled	Factory Default	Press and hold Cancel and Keep	Allows the clock to be reset to factory
		Warm pads for 3 to 5 seconds until	settings.
		beep sounds.
M1 Controlled	Twelve hour off	Control will automatically cancel any	See Sabbath mode to disable.
		cooking operation and remove all relay
		drives 12 hours after the last pad
		touch.
M1 Controlled	Sabbath Mode	Hold Clock pad for 3 to 5 seconds to	"SAb" will be displayed and flash for 5
		activate Sabbath mode.	seconds then remain on until until timed-
			out or cancelled.
		Hold Clock pad for 3 to 5 seconds to	The status “SAB” is NOT fault code 5A6.
		disable Sabbath mode.	All pad inputs are disabled except for
			CANCEL and CLOCK pads.
		Desired bake function must be	This mode disables the normal 12 hour
		initiated before entering Sabbath	shutoff to allow operation of the bake
		mode.	mode for a maximum of 72 hours.
			The oven light is not disabled.
M1 Controlled	Child lock out	Press and hold Cancel and Cook &	This is a safety feature that can be used
		Hold pads for 3 to 5 seconds until	to prevent children from accidentally
		beep sounds.	programming the oven. It disables the
		To reactivate the control, press and	electronic oven control.
		hold Cancel and Cook & Hold pads	Child lockout features must be reset after
		for 3 to 5 seconds.
			a power failure.
M1 Controlled	Diagnostic Code	Press and hold More + pad within 60	The last 5 diagnostic codes will be stored
	Display	seconds of powering up the unit.	in the non-volatile memory.
		Cycle through the codes using the	See "Description of Error Codes" for
		More + or Less - pads.
			explanation.

16 16023522 ©2004 Maytag Services