Maytag CGR1125ADQ/W, CPL1100ADH/L/Q/T/W, AGR5712ADB/Q/S/W, CPL1110ADH/L/T Installation Drawings

Installation Instructions (Models CPL1100AD*, CGL1100AD*)

INSTALLATION DRAWINGS

BACKGUARD INSTALLATION

(if not installed)

The backguard fits on the range as shown in figure 1 and is secured with a bracket, 2 bolts and nuts on each side.

Set the backguard on the rear of the range. Bolt the backguard to the end panel flanges.

FIGURE 1

DISCONNECT ELECTRICAL POWER TO AVOID SHOCK HAZARD.

CLEARANCE DIMENSIONS

All free-standing ranges can be installed with the back against (0 inches) a vertical combustible wall, and the sides below the cooking surface against (0 inches) combustible base cabinets. For complete information in regard to the installation of wall cabinets above the range and clearances to combustible surfaces see the installation drawings and/or the model number plate on the range. For SAFETY CONSIDERATIONS do not install a range in any combustible cabinetry which is not in accord with the installation drawings and the clearance given on the range Model Number Plate.

LOCATING THE RANGE

Do not set range over holes in the floor or other locations where it may be subject to strong drafts. Any opening in the wall behind the range and in the floor under the range should be sealed. Make sure the flow of cooling/ventilation air is not obstructed below the range.

NOTE: A range should NOT be installed directly over kitchen carpeting.

-3-

A–5 16023522 ©2004 Maytag Services