Cooktop & Installation Manual
Model COGB ENGLISH
Conversion LP Gas
Converting Appliance for Use with LP Gas
WARNING
Conversion is to be performed by a AUTHORIZED SERVICER (or other qualified agency) in accordance with the manufacturer's instructions and all codes and requirements of the authority having jurisdiction.
Failure to follow instructions could result in serious injury or property damage.
The qualified agency performing this work assumes responsibility for this conversion.
WARNING
Electrical power and gas must be turned off prior to conversion.
If this appliance should be converted for use with gas LP (propane or butane), each of the following modification must be performed:
Replace all Injectors
1.Remove the grates and burner caps.
2.Remove aluminum gas spreader.
3.Loosen injectors by turning
4.Change the NG injectors with the LP injectors supplied with this appliances .The injectors have small numbers stamped on the side, this number codes the orifice diameter and its correct burner location.
5.Install the 4 injector in the appropriate burner turning clockwise to tighten
(Tighten to a torque of 15 to 20
Carefully install the injector in the appropriate burner, following the illustrations below.
6.Replace aluminum gas spreader, burner caps and grates.
7.Save the orifices removed from the appliance for future use.
017 |
Figure 17.
90 | 105 |
115 | 75 |
| 018 |
Figure 18. 4 burner Model (30” wide)
16