Multiquip operation manual DCA-125USJ 50 HZ-TRAILER Specifications, Explanation of Chart

Page 17

DCA-125USJ (50 HZ)—TRAILER SPECIFICATIONS

CAUTION:

5. Frame Width - Measurement is from fender to fender

ALWAYS make sure the trailer is in good operating condition. Check the tires for proper inflation and wear. Also check the wheel lug nuts for proper tightness.

Explanation of Chart:

This section is to provide the user with trailer service and maintenance information. The service and maintenance guidelines referenced in this section apply a wide range of trailers. Remember periodic inspection of the trailer will en- sure safe towing of the equipment and will prevent damage to the equipment and personal injury.

6.Jack Stand - Trailer support device with maximum pound requirement from the tongue of the trailer.

7.Coupler - Type of hitch used on the trailer for towing.

8.Tire Size - Indicates the diameter of the tire in inches (10,12,14, etc.), and the width in millimeters (175,185,205, etc.). The tire diameter must match the diameter of the tire rim.

9.Tire Ply - The tire ply (layers) number is rated in letters; 2-ply,4-ply,6-ply, etc.

10.Wheel Hub - The wheel hub is connected to the trailer’s axle.

11.Tire Rim - Tires mounted on a tire rim. The tire rim must match the size of the tire.

It is the purpose of this section to cover the major mainte- nance components of the trailer. The following trailer com- ponents will be discussed in this section:

„Brakes

„Tires

„Lug Nut Torquing

„Suspension

„Electrical

„Brake Troubleshooting Tables

Use the following definitions when reading Table 2.

1.Fuel Cell - Provides an adequate amount of fuel for the equipment in use. Fuel cells must be empty when trans- porting equipment.

2.Braking System - System employed in stopping the trailer. Typical braking systems are electric, surge, hy- draulic, hydraulic-surge and air.

3.GVWR- Gross Vehicle Weight Rating (GVWR), is the maximum number of pounds the trailer can carry, in- cluding the fuel cell (empty).

4.Frame Length - Measurement is from the ball hitch to the rear bumper (reflector).

12.Lug Nuts - Used to secure the wheel to the wheel hub. Always use a torque wrench to tighten down the lug nuts. See Table 17 and Figure 67 for lug nut tightening and sequence.

13.Axle - Indicates the maximum weight the axle can sup- port in pounds, and the diameter of the axle expressed in inches. Please note that some trailers have a double axle. This will be shown as 2-6000 lbs., meaning two axles with a total weight capacity of 6000 pounds.

14.Suspension - Protects the trailer chassis from shocks transmitted through the wheels. Types of suspension used are leaf, Q-flex, and air ride.

15.Electrical - Electrical connectors (looms) are provided with the trailer so the brake lights and turn signals can be connected to the towing vehicle.

16.Application - Indicates which units can be employed on a particular trailer.

DCA-125USJ (50 HZ) — OPERATION AND PARTS MANUAL — REV. #0 (03/11/05) — PAGE 17

Image 17
Contents Model DCA-125USJ Page Wilmington Ave Carson, CA Heres HOW to GET HelpTable of Contents When ordering parts Please supply the following information Parts Ordering ProceduresDCA-125USJ 50 HZ- Specifications Dimensions DCA-125USJ 50 HZ- Dimensions TOP, Side and FrontFor Your Safety and the Safety of Others DCA-125USJ 50 HZ Safety Message Alert SymbolsOver Speed Conditions Sight and Hearing hazard DCA-125USJ 50 HZ Safety Message Alert SymbolsDCA-125USJ 50 HZ Rules for Safe Operation Radiator DCA-125USJ 50 HZ Rules for Safe OperationElectrical shock, electrocution, and even death Transporting BatteryDCA-125USJ 50 HZ- Rules for Safe Operation DCA-125USJ 50 HZ- Rules for Safe Operation Towing Safety PrecautionsDCA-125USJ 50 HZ- Installation Mounting DCA-125USJ 50 HZ- InstallationOutdoor Installation Generator with Trailer DCA-125USJ 50 HZ-TOWING Safety PrecautionsExplanation of Chart DCA-125USJ 50 HZ-TRAILER SpecificationsFrame Width Measurement is from fender to fender Coupler Type of hitch used on the trailer for towingGenerator Decals DCA-125USJ 50 HZ- Generator DecalsDCA-125USJ 50 HZ- Generator Decals DCA-125USJ 50 HZ- General Information Generator Major Components DCA-125USJ 50 HZ- Major ComponentsPage Generator Control Panel DCA-125USJ 50 HZ- Generator Control PanelEngine Operating Panel DCA-125USJ 50 HZ- Engine Operating PanelDCA-125USJ 50 HZ- Engine Operating Panel Output Terminal Familiarization DCA-125USJ 50 HZ- Output Terminal Panel FamiliarizationTwist Lock Dual Voltage 100/200 VAC Receptacles 100VAC Gfci ReceptaclesBlower Fan Connecting LoadsThree Phase Load Single Phase LoadDCA-125USJ 50 HZ- Load Application Motors and motor-drivenDCA-125USJ 50 HZ- Generator Outputs Voltage Selector SwitchGenerator OutputVoltages Generator AmperageReading Amperage How to Read the OutputTerminal GaugesDCA-125USJ 50 HZ- Gauge Reading Uvwo Terminal Output Voltages DCA-125USJ 50 HZ- Output Terminal Panel Connections3Ø 220/127 Output Terminal Lug Voltages 3Ø 200V/1Ø115V Output Terminal Lug Voltages1Ø 200V/100V Output Terminal Lug Voltages DCA-125USJ 50 HZ- Output Terminal Panel Connections3Ø 440/254 Output Terminal Lug Voltages Circuit Breakers DCA-125USJ 50 HZ- PRE-SETUPLubrication Oil Fuel CheckRefueling Procedure DCA-125USJ 50 HZ- PRE-SETUPContact and/or inhaling fumes ALWAYS! place trailer on firm level ground before refuelingAir Cleaner Fan Belt Tension Cleaning the RadiatorOperation FreezingWeather Must be less than 50%When connecting battery do the following Battery Cable InstallationWiring AlternatorBefore Starting DCA-125USJ 50 HZ- Generator START-UP Procedure ManualLED on Starting ManualOil Pressure Gauge Starting Auto Mode DCA-125USJ 50 HZ- Generator START-UP Procedure Auto ModeShutdown Procedure DCA-125USJ 50 HZ- Generator SHUT-DOWN ProcedureEmergency Shutdown Procedure DCA-125USJ 50 HZ- Maintenance Check Oil Level Air RemovalReplacing Oil Filter Replacing Fuel FilterDCA-125USJ 50 HZ Operation and Parts Manual REV. #0 03/11/05 Brake Adjustment DCA-125USJ 50 HZ-TRAILER Brakes MaintenanceBrakes Hydraulic Surge BrakesTires/Wheels/Lug Nuts DCA-125USJ 50 HZ-TRAILER MaintenanceTire Wear/Inflation SuspensionStart all wheel lug nuts by hand DCA-125USJ 50 HZ-TRAILER MaintenanceLug Nut Torque Requirements Trailer/Towing Vehicle Wiring Diagram DCA-125USJ 50 HZ-TRAILERWIRING DiagramGenerator Wiring Diagram DCA-125USJ 50 HZ- Generatorwiring DiagramEngine Wiring Diagram DCA-125USJ 50 HZ- Enginewiring DiagramGenerator Troubleshooting DCA-125USJ 50 HZ-TROUBLESHOOTING GeneratorEngine Controller Troubleshooting DCA-125USJ 50 HZ-TROUBLESHOOTING Engine ControllerItems Found In the Items Number Column Explanation of Code in Remarks ColumnQty Description To 3 UnitsDCA-125USJ 50 HZ- Generator Assy DCA-125USJ 50 HZ- Generator Assy DCA-125USJ 50 HZ- Control BOX Assy 0330000180 M32130007020601808823 LAF3630010393PDCA-125USJ 50 HZ- Control BOX Assy DCA-125USJ 50 HZ- Control BOX Assy DCA-125USJ 50 HZ- Engine and Radiator Assy 0602041292 M3923200054RE504836 0602042594Engine & Radiator Assy DCA-125USJ 50 HZ- Engine and Radiator Assy DCA-125USJ 50 HZ- Outputterminal Assy DCA-125USJ 50 HZ- Outputterminal Assy DCA-125USJ 50 HZ- Battery Assy 4D-2 0602220196M9310500404 M9103000504DCA-125USJ 50 HZ- Muffler Assy 0017112030 M3330100402M3333000903 M3333200304DCA-125USJ 50 HZ- Fueltank Assy DCA-125USJ 50 HZ- Fuel Tank Assy Enclosure #1 Assy DCA-125USJ 50 HZ- Enclosure #1 AssyM3363300303 M34130018120016910030 0603306797DCA-125USJ 50 HZ- Enclosure #1 Assy 24A M3493201204 24A M34932006140010114040 25A 0030014000Enclosure #2 Assy DCA-125USJ 50 HZ- Enclosure #2 AssyM3443000812 M3443000802M3493303203 M3443000904DCA-125USJ 50 HZ- Rubber Seals Assy 0229201130 02292008700229201240 0228900660DCA-125USJ 50 HZ- Nameplate and Decals Assy M15000020 M1550000204M1550000703 M15000070Terms and Conditions of Sale Parts DCA-125USJ 50 HZ Operation and Parts Manual REV. #0 03/11/05 Your Local Dealer is