Multiquip DCA-125USJ Air Removal, Check Oil Level, Replacing Oil Filter, Replacing Fuel Filter

Page 44

DCA-125USJ (50 HZ)— MAINTENANCE

Air Removal

If air enters the fuel injection system of a diesel engine, starting becomes impossible. After running out of fuel, or after disassembling the fuel system, bleed the system according to the following procedure. See the John Deere Engine Manual for details.

Check Oil Level

Check the crankcase oil level prior to each use, or when the fuel tank is filled. Insufficient oil may cause severe damage to the engine. Make sure the generator is level. The oil level must be between the two notches on the dipstick as shown in Figure 33.

Replacing Oil Filter

Remove the old oil filter.

Apply a film of oil to the gasket on the new oil filter.

Install the new oil filter.

After the oil cartridge has been replaced, the engine oil will drop slightly. Run the engine for a while and check for leaks before adding more oil if needed. Clean excessive oil from engine.

Replacing Fuel Filter

Replace the fuel filter cartridge with new one every 500 hours or so.

Loosen the drain plug at the lower top of the fuel filter. Drain the fuel in the fuel body together with the mixed water. DO NOT spill the fuel during disassembly.

Vent any air.

Flushing Out Radiator and Replacing Coolant

zOpen both cocks located at the crankcase side and at the lower part of the radiator and drain coolant. Open the radiator cap while draining. Remove the overflow tank and drain.

zCheck hoses for softening and kinks. Check clamps for signs of leakage.

zFlush the radiator by running clean tap water through radiator until signs of rust and dirt are removed. DO NOT clean radiator core with any objects, such as a screwdriver.

zTighten both cocks and replace the overflow tank.

zReplace with coolant as recommended by the engine manufaturer.

zClose radiator cap tightly.

CAUTION:

Allow engine to cool when flushing out radiator.Flushing the radiator while hot could cause serious burns

from water or steam.

Generator Storage

For longe term storage of the generator the following is recommended:

zFill the fuel tank completely. Treat with a fuel stabilizer if necessary.

zCompletely drain the oil from the crankcase and refill if necessary with fresh oil.

zClean the entire generator, internal and external.

zCover the generating set and store in a clean, dry place.

zDisconnect the battery.

zMake sure engine coolant is at proper level.

zIf generator is mounted on a trailer, jack trailer up and place on blocks so tires do not touch the ground or block and completely remove the tires.

PAGE 44 — DCA-125USJ (50 HZ) — OPERATION AND PARTS MANUAL — REV. #0 (03/11/05)

Image 44
Contents Model DCA-125USJ Page Heres HOW to GET Help Wilmington Ave Carson, CATable of Contents Parts Ordering Procedures When ordering parts Please supply the following informationDCA-125USJ 50 HZ- Specifications DCA-125USJ 50 HZ- Dimensions TOP, Side and Front DimensionsDCA-125USJ 50 HZ Safety Message Alert Symbols For Your Safety and the Safety of OthersDCA-125USJ 50 HZ Safety Message Alert Symbols Over Speed Conditions Sight and Hearing hazardDCA-125USJ 50 HZ Rules for Safe Operation Radiator DCA-125USJ 50 HZ Rules for Safe OperationElectrical shock, electrocution, and even death Transporting BatteryDCA-125USJ 50 HZ- Rules for Safe Operation Towing Safety Precautions DCA-125USJ 50 HZ- Rules for Safe OperationDCA-125USJ 50 HZ- Installation Mounting DCA-125USJ 50 HZ- InstallationOutdoor Installation DCA-125USJ 50 HZ-TOWING Safety Precautions Generator with TrailerDCA-125USJ 50 HZ-TRAILER Specifications Explanation of ChartFrame Width Measurement is from fender to fender Coupler Type of hitch used on the trailer for towingDCA-125USJ 50 HZ- Generator Decals Generator DecalsDCA-125USJ 50 HZ- Generator Decals DCA-125USJ 50 HZ- General Information DCA-125USJ 50 HZ- Major Components Generator Major ComponentsPage DCA-125USJ 50 HZ- Generator Control Panel Generator Control PanelDCA-125USJ 50 HZ- Engine Operating Panel Engine Operating PanelDCA-125USJ 50 HZ- Engine Operating Panel DCA-125USJ 50 HZ- Output Terminal Panel Familiarization Output Terminal Familiarization100VAC Gfci Receptacles Twist Lock Dual Voltage 100/200 VAC ReceptaclesConnecting Loads Blower FanSingle Phase Load Three Phase LoadDCA-125USJ 50 HZ- Load Application Motors and motor-drivenVoltage Selector Switch DCA-125USJ 50 HZ- Generator OutputsGenerator OutputVoltages Generator AmperageReading Amperage How to Read the OutputTerminal GaugesDCA-125USJ 50 HZ- Gauge Reading DCA-125USJ 50 HZ- Output Terminal Panel Connections Uvwo Terminal Output Voltages3Ø 220/127 Output Terminal Lug Voltages 3Ø 200V/1Ø115V Output Terminal Lug Voltages1Ø 200V/100V Output Terminal Lug Voltages DCA-125USJ 50 HZ- Output Terminal Panel Connections3Ø 440/254 Output Terminal Lug Voltages DCA-125USJ 50 HZ- PRE-SETUP Circuit BreakersLubrication Oil Fuel CheckDCA-125USJ 50 HZ- PRE-SETUP Refueling ProcedureContact and/or inhaling fumes ALWAYS! place trailer on firm level ground before refuelingCleaning the Radiator Air Cleaner Fan Belt TensionOperation FreezingWeather Must be less than 50%Battery Cable Installation When connecting battery do the followingWiring AlternatorDCA-125USJ 50 HZ- Generator START-UP Procedure Manual Before StartingStarting Manual LED onOil Pressure Gauge DCA-125USJ 50 HZ- Generator START-UP Procedure Auto Mode Starting Auto ModeShutdown Procedure DCA-125USJ 50 HZ- Generator SHUT-DOWN ProcedureEmergency Shutdown Procedure DCA-125USJ 50 HZ- Maintenance Air Removal Check Oil LevelReplacing Oil Filter Replacing Fuel FilterDCA-125USJ 50 HZ Operation and Parts Manual REV. #0 03/11/05 DCA-125USJ 50 HZ-TRAILER Brakes Maintenance Brake AdjustmentBrakes Hydraulic Surge BrakesDCA-125USJ 50 HZ-TRAILER Maintenance Tires/Wheels/Lug NutsTire Wear/Inflation SuspensionStart all wheel lug nuts by hand DCA-125USJ 50 HZ-TRAILER MaintenanceLug Nut Torque Requirements DCA-125USJ 50 HZ-TRAILERWIRING Diagram Trailer/Towing Vehicle Wiring DiagramDCA-125USJ 50 HZ- Generatorwiring Diagram Generator Wiring DiagramDCA-125USJ 50 HZ- Enginewiring Diagram Engine Wiring DiagramDCA-125USJ 50 HZ-TROUBLESHOOTING Generator Generator TroubleshootingDCA-125USJ 50 HZ-TROUBLESHOOTING Engine Controller Engine Controller TroubleshootingExplanation of Code in Remarks Column Items Found In the Items Number ColumnTo 3 Units Qty DescriptionDCA-125USJ 50 HZ- Generator Assy DCA-125USJ 50 HZ- Generator Assy DCA-125USJ 50 HZ- Control BOX Assy M3213000702 03300001800601808823 LAF3630010393PDCA-125USJ 50 HZ- Control BOX Assy DCA-125USJ 50 HZ- Control BOX Assy DCA-125USJ 50 HZ- Engine and Radiator Assy M3923200054 0602041292RE504836 0602042594Engine & Radiator Assy DCA-125USJ 50 HZ- Engine and Radiator Assy DCA-125USJ 50 HZ- Outputterminal Assy DCA-125USJ 50 HZ- Outputterminal Assy DCA-125USJ 50 HZ- Battery Assy 0602220196 4D-2M9310500404 M9103000504DCA-125USJ 50 HZ- Muffler Assy M3330100402 0017112030M3333000903 M3333200304DCA-125USJ 50 HZ- Fueltank Assy DCA-125USJ 50 HZ- Fuel Tank Assy DCA-125USJ 50 HZ- Enclosure #1 Assy Enclosure #1 AssyM3413001812 M33633003030016910030 0603306797DCA-125USJ 50 HZ- Enclosure #1 Assy 24A M3493200614 24A M34932012040010114040 25A 0030014000DCA-125USJ 50 HZ- Enclosure #2 Assy Enclosure #2 AssyM3443000802 M3443000812M3493303203 M3443000904DCA-125USJ 50 HZ- Rubber Seals Assy 0229200870 02292011300229201240 0228900660DCA-125USJ 50 HZ- Nameplate and Decals Assy M1550000204 M15000020M1550000703 M15000070Terms and Conditions of Sale Parts DCA-125USJ 50 HZ Operation and Parts Manual REV. #0 03/11/05 Your Local Dealer is