![](/images/new-backgrounds/1098980/9898019x1.webp)
NOTES
NOTE
HARDWARE DAMAGE! Engine and generator may make use of both American Standard and metric hardware. Be sure to use the correct size tools to prevent rounding of bolt heads and nuts.
NOTE
Special attention should be given when checking for proper coolant level. After the coolant has been drained, it normally requires some time before complete refill of the engine water jacket takes place.
NOTE
When replacing hardware, do not substitute with inferior grade hardware. Screws and nuts are available in different hardness ratings. American Standard hardware uses a series of markings and metric hardware uses a numeric system to indicate hardness. Check markings on bolt head and nuts for proper identification.
NOTE
When a fuse replacement is required, be sure fuse has the same ampere rating and is the same type (for example: ABC or 3AB, ceramic). Do not substitute “clear”
NOTE
NOTICE
This generator set has been rewired from its nameplate voltage to:
246242
NOTICE
This is a positive terminal only.
Do not attach negative lead!
NOTICE
Check zinc anode every 100 hours or 3 months.
NOTICE
Do not use as a step.
Standing on genset could impair operation of unit.
NOTE
Split lock washers may be supplied with some kits. If split lock washers are supplied with kit, their use is optional.
Safety Precautions and Instructions vii |