Kohler 13ERG, 15ERG, 10ERG manual Volt, 2-Wire Configuration For Models with ADC

Page 37

200-240-Volt Configurations

The 200--240-volt configuration does not use a jumper lead. If the unit was originally wired for straight 100--120 volt, 3 wire, remove the jumper lead (see Figure 8-1 for location).

L0 (Neutral)

				L0
			Ground	GRD.
			Ground
		Load		L1
		Load
		Side
		Line	Single-Pole
		Side	Circuit
			Breaker
			Tape to insulate
			from ground
4	1	3	2
			200-220-240 Volt
Stator Leads			2 Wire

60 Hz

L0--L1 200-240 Volt

Figure 8-4 200--220--240-Volt, 2-Wire Configuration

for Models with ADC 2100

TP-6335 9/04

Reconnection/Adjustments 27

Image 37

Contents TP-6335 9/04 ModelPage Table of Contents Page Battery Safety Precautions and InstructionsAccidental Starting Exhaust System Engine Backfire/Flash FireHazardous Noise Fuel SystemHazardous Voltage/ Electrical Shock Moving Parts Hot Parts246242 VI Safety Precautions and Instructions TP-6335 9/04 Generator Set Specifications Installation StandardsIntroduction Generator Set OperationIntroduction TP-6335 9/04 General Considerations Location and MountingLocation Vehicle-Floor MountingLocation and Mounting TP-6335 9/04 Cooling System High Water Temperature SwitchAir Requirements Block HeatersCooling System TP-6335 9/04 Exhaust System Clearance Requirements PlanningExhaust Piping, If Used Gasoline Fuel SystemLP Gas Fuel Filters or StrainersFuel Lines Fuel Pump Lift Capability Max., Gasoline Models Fuel Pump Lift and Fuel ConsumptionFuel System TP-6335 9/04 Electrical Connections Electrical SystemAC Load Lead Connections Transfer Switch Connections Wire AC Circuit Circuit Breaker Considerations Circuit ProtectionElectrical Connections Circuit Breaker InstallationADC 2100 Continuous Power Mode Jumper CCA Battery and ConnectionsView B Remote ConnectionElectrical System TP-6335 9/04 Dimension Drawing, Gasoline Fuel System Installation DrawingDimension Drawing, LP Fuel System Dimension Drawing, Floor Template Installation Drawing TP-6335 9/04 Reconnection/Adjustments Four-Lead Reconnection 100--120-Volt, 2-Wire Configuration200--220--240-Volt, 2-Wire Configuration For Models with ADC Advanced Digital Control ADC Configuration Mode Time OutController Software Version Number Voltage Adjustment Adjusting the Voltage, Gain, and Volts/HzOn Figure Output Voltage Adjustment ModeFrom Figure V EController Configuration Controller Parameters N c V E 11 Save Mode after configuring generator set parameters Reconnection/Adjustments TP-6335 9/04 General Wattage Requirements Appendix a Generator Selection and Wattage RequirementsAnsi Appendix B AbbreviationsLCB Page Page By Kohler Co. All rights reserved