Kohler 15ERG, 13ERG, 10ERG manual Transfer Switch Connections Wire AC Circuit

Note: Transfer switch. Use a triple-pole, double-throw transfer switch rated for the calculated load of the vehicle to transfer the load from one source to the other. Install a ground-fault circuit interrupter in the wiring system to protect all branch circuits.

Note: AC load circuit protection. Protect the AC load circuit of the generator set against overloading or short circuiting with a circuit breaker(s).

Note: For standby service connect output of the generator to a suitably rated transfer switch in accordance with the Canadian Electrical Code, Part 1.

		AC Vehicle Circuit
		Ground Fault
		Circuit Protection
		L0
N	N	N
120-V
Outside		L1
Power			Gen.
			Set
		L2
		120 Volt
		AC Vehicle Circuit
		Ground Fault
		Circuit Protection
		L0
N	N	N
240-V
Outside		L1
Power			Gen.
			Set
		L2
		240 Volt

Figure 6-1 Transfer Switch Connections,

3-Wire AC Circuit

14 Electrical System TP-6335 9/04