Guardian Technologies 004270-3 owner manual Purpose and Scope Manual, Standards Booklets

Page 22

Section 1 – General Information

QUIETPACT™ 75D Recreational Vehicle Generator

1.1PURPOSE AND SCOPE

OF THE MANUAL

These Installation Instructions have been prepared especially for the purpose of familiarizing installers and owners of the applicable equipment with the product's installation requirements. Give serious consideration to all information and instructions in the manual, both for safety and for continued reliable operation of the equipment.

Because of the different recreational vehicle models and the variations between the models, it would be extremely difficult, if not impractical, to provide detailed instructions for every possible installation. For that reason, instructions and illustrations in this manual are general in nature. Illustrations are not intended to serve as detailed installation blueprints.

The installation should comply strictly with all applicable codes, standards, and regulations pertain- ing to the installation and use of this product. If any portion of this manual appears to be in conflict with such codes, standards, or regulations, the applicable codes, standards, or regulations must take prece- dence over the manual.

1.2SAFETY

Before handling, installing, operating, or servicing this equipment, carefully read the “Notice to Installer” and “Safety Rules” on Pages 18 and 19. Comply with all safety rules to prevent death, per- sonal injury, or damage to equipment and/or proper- ty. Stress safety to all installers, operators, and ser- vice technicians who work on this equipment.

1.3STANDARDS BOOKLETS

Installation, use, and servicing of this equipment should comply strictly with published standards, as well as the manufacturer's recommendations. The following standards booklets (latest revision) are available from the sources indicated:

1.NFPA 1192, “Standard for Recreational Vehicles” (replaces ANSI A119.2/NFPA 501C), available from the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.

2.NFPA 70, “NFPA Handbook of the National Electric Code,” available same as Item 1.

3.ANSI/RVIA EGS-1, “Engine Generator Sets for Recreational Vehicle Safety Requirements”, ava- ialable from the Recreational Vehicle Industry Association, 1896 Preston White Drive, Reston, VA 22090.

4.California Administrative Code, Title 25, avail- able from the State of California, Documents Section, P.O. Box 1015, North Highlands, CA 95660.

5.CSA Electrical Bulletin 946, available from the Canadian Standards Association, Housing and Constructions Materials Section, 178 Rexdale Boulevard, Rexdale, Ontario, Canada, M9W 1R3.

1.4EQUIPMENT DESCRIPTION

Instructions and information in this section pertain to Generac liquid-cooled generators, designed specifically for installing in recreational vehicles. The QUIETPACT 75D operates 120/240-volt, single-phase, 60-Hertz, AC electrical loads that require up to 62.5 amps at 120 volts or 31.2 amps at 240 volts.

1.5GENERATOR ENGINE

OPERATING SPEED

The generator’s two-pole revolving field (rotor) is dri- ven by a three-cylinder, 1.0-liter diesel engine. The generator supplies 120/240 volts AC at 60 Hertz, when the rotor is operating at 3,600 rpm. Engine speed is held nearly constant by a mechanical, fixed speed governor at 1,950 rpm.

1.6GENERATOR AC

CONNECTION SYSTEM

The generator is equipped with dual stator power windings, as shown in Figure 1.1.

Figure 1.1 – Connections for 120/240 Dual

Voltage

•The AC connection system uses a GROUNDED neutral. A separate green ground wire is connected to the recreational vehicle’s junction box.

•For this QUIETPACT™ unit, each stator winding can support 120-volt, 60-Hertz, AC electrical output (3,600 rpm). When the two stator windings are con- nected in series, the unit can generate an output of 240 volts AC.

NOTE:

Do NOT connect loads in excess of circuit breaker ratings.

20 Generac® Power Systems, Inc.

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Liquid-cooled Recreational Vehicle Generator Authorized Service Dealer Location IntroductionPart II Installation Instructions Table of ContentsGeneral Hazards Electrical Hazards Model Generator IdentificationQuietpact 75D Generator Applicability SafetySpecifications Generator AC Connection SystemCoolant Fuel Consumption GAL/HREngine OIL Requirements EngineOptional Remote START/STOP Generator Control PanelBefore Starting the Engine Starting the Generator Stopping the Generator Protection SystemsOvervoltage Protection Additional InformationOverspeed Shutdown 1 25-HOUR BREAK-IN PeriodOperation in High Grass or Brush Checking the Engine OIL LevelChanging the Engine OIL AND/OR OIL Filter Effects of Moisture and DirtServicing the Engine AIR Filter Spark Arrestor MufflerCleaning the Generator Battery MaintenanceDrive Belt Cooling SystemEngine Coolant Exercising the GeneratorRemoval from Service OUT-OF-SERVICE ProcedureReturn to Service Service Schedule Part General Hazards Fire Hazards Equipment Description Purpose and Scope ManualStandards Booklets Generator Engine Operating SpeedMajor Features and Dimensions Generator Support Location and SupportGenerator Location Suspended MountingGenerator Restraint Generator CompartmentsCompartment Construction Sound Insulating Materials AcousticsTypical Noise Abatement 2.2.4 Compartment Floor Cutouts Cooling AIR Inlet Openings Cooling and Ventilating AIRGenerator Airflow Diesel Fuel System Testing the InstallationCompensating for Restrictions Generator Fuel Supply Lines Fuel TankGenerator Fuel Return Lines Exhaust System Exhaust System SafetyMuffler and Spark Arrestor Electrical Junction BOX WiringElectrical Connections Generator AC ConnectionsGenerator Coversion to Volts Only Dual CircuitsIsolating Different Power Sources Power Supply CordConduit Battery Cables Battery InstallationRecommended Battery Battery Cable ConnectionsBattery Compartment Optional AccessoriesRemote START/STOP Connections Before Initial Startup Post Installation TestsTesting Under Load Initial StartInstallation Checklist Troubleshooting Guide Problem Cause CorrectionAppendix 2 Notes Appendix 2 Notes Appendix 3 Electrical Data Appendix 3 Electrical Data Appendix 3 Electrical Data Wiring Diagram 120 VAC- Drawing No. 0D2793-B Part Part NO. QTY Description 677mm Frame Control Panel Refer to Drawing Hose, ¾ SAE-20R3 Gasket, Electrical Enclosure Divider To Engine AIR Intake 0C6946A Fuel Pump Assembly 023484F Snap Bushing 052219 1917 2118 11 29 32 33 QTY Description Complete Cylinder Block Cylinder Head Assembly Complete Crankshaft Idler Gear Assembly Rocker ARM Assembly Injection Pump Assembly Fuel Filter HOUSING, Timing Gear OIL PAN 1413 Appendix 5 Notes Manufacturers Warranty Coverage Federal and California Emissions Control Warranty StatementYour Warranty Rights and Obligations Parts CoveredObligations and Rights of the Manufacturer and Owner Obtaining Warranty ServiceLimitations Warranty Schedule CONSUMER/PERSONAL Applications
Top Page Image Contents