Guardian Technologies 004270-3 Federal and California Emissions Control Warranty Statement

Page 66

Appendix 6 – Warranty

QUIETPACT™ 75D Recreational Vehicle Generator

FEDERAL AND CALIFORNIA EMISSIONS CONTROL WARRANTY STATEMENT

(for non-road Diesel engines rated under 19 kW)

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), Generac Power Systems, Inc. (GENERAC), and the engine manufacturer for this equipment, Ishikawajima Shibaura Machinery Co., Ltd. (ISM), are pleased to explain the federal and California emission control system warranty on your engine.

In California, new 2000 and later small non-road engines must be designed, built, and equipped to meet the state's strin- gent anti-smog standards. In other states, new 2000 and later non-road diesel engines rated under 19 kW must be designed, built, and equipped to conform to applicable EPA regulations.

ISM must warrant the emission control system on your engine for that period of time listed below, provided there has been no abuse, neglect, or improper maintenance of your small non-road diesel engine.

Your California and EPA emission control system may include parts, such as, the fuel injection system and other emission- related assemblies.

Where a warrantable condition exists, GENERAC will repair your engine at no cost to you, including diagnosis, parts, and labor, on behalf of ISM. Although ISM is ultimately responsible for this warranty, GENERAC has agreed to carry out ISM's warranty repair responsibilities, and GENERAC should be your primary contact for emission-related warranty service.

MANUFACTURER'S WARRANTY COVERAGE

For 2000 and later small non-road diesel engines, first sold in California, and for 2000 and later non-road diesel engines rated under 19 kW, first sold in all other states, the applicable warranty period is two (2) years or 1,500 hours, whichever comes first.

If any emission-related part on your engine is defective, the part will be repaired or replaced by a Generac Authorized Warranty Service Facility on behalf of ISM.

PARTS COVERED

This emission control system warranty applies to the following engine emission control parts.

• Fuel Injection Pump

• Fuel Injectors

• Intake Manifold

• Exhaust Manifold

• Air Cleaner Element

• Miscellaneous Hoses, Bolts and Connectors

 

OWNER'S WARRANTY RESPONSIBILITIES

As the engine owner, you are responsible for the performance of the required maintenance listed in your Owner's Manual. GENERAC and ISM recommend that you retain the original purchase documentation and all receipts covering maintenance on your engine, but GENERAC and ISM cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the engine owner, you should be aware, however, that GENERAC and ISM may deny you warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance, or unapproved modifications.

You are responsible for contacting a Generac Authorized Warranty Service Facility as soon as a problem occurs. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

Warranty Service can be arranged by contacting either your selling dealer or a Generac Authorized Warranty Service Facility. To locate the Generac Authorized Warranty Service Facility nearest you, call our toll-free number:

1-800-333-1322

If you have any questions regarding your warranty rights and responsibilities, you should contact GENERAC at the following address:

ATTENTION WARRANTY DEPARTMENT

GENERAC POWER SYSTEMS, INC.

211 MURPHY DRIVE

EAGLE, WI 53119

Page 1

64 Generac® Power Systems, Inc.

Image 66
Contents Liquid-cooled Recreational Vehicle Generator Authorized Service Dealer Location IntroductionPart II Installation Instructions Table of ContentsGeneral Hazards Electrical Hazards Generator Identification ModelQuietpact 75D Generator Applicability SafetySpecifications Generator AC Connection SystemCoolant Fuel Consumption GAL/HREngine OIL Requirements EngineGenerator Control Panel Optional Remote START/STOPBefore Starting the Engine Starting the Generator Stopping the Generator Protection SystemsOvervoltage Protection Additional InformationOverspeed Shutdown 1 25-HOUR BREAK-IN PeriodOperation in High Grass or Brush Checking the Engine OIL LevelChanging the Engine OIL AND/OR OIL Filter Effects of Moisture and DirtServicing the Engine AIR Filter Spark Arrestor MufflerCleaning the Generator Battery MaintenanceDrive Belt Cooling SystemEngine Coolant Exercising the GeneratorOUT-OF-SERVICE Procedure Removal from ServiceReturn to Service Service Schedule Part General Hazards Fire Hazards Equipment Description Purpose and Scope ManualStandards Booklets Generator Engine Operating SpeedMajor Features and Dimensions Generator Support Location and SupportGenerator Location Suspended MountingGenerator Compartments Generator RestraintCompartment Construction Sound Insulating Materials AcousticsTypical Noise Abatement 2.2.4 Compartment Floor Cutouts Cooling and Ventilating AIR Cooling AIR Inlet OpeningsGenerator Airflow Testing the Installation Diesel Fuel SystemCompensating for Restrictions Fuel Tank Generator Fuel Supply LinesGenerator Fuel Return Lines Exhaust System Safety Exhaust SystemMuffler and Spark Arrestor Electrical Junction BOX WiringElectrical Connections Generator AC ConnectionsGenerator Coversion to Volts Only Dual CircuitsPower Supply Cord Isolating Different Power SourcesConduit Battery Cables Battery InstallationRecommended Battery Battery Cable ConnectionsOptional Accessories Battery CompartmentRemote START/STOP Connections Before Initial Startup Post Installation TestsTesting Under Load Initial StartInstallation Checklist Troubleshooting Guide Problem Cause CorrectionAppendix 2 Notes Appendix 2 Notes Appendix 3 Electrical Data Appendix 3 Electrical Data Appendix 3 Electrical Data Wiring Diagram 120 VAC- Drawing No. 0D2793-B Part Part NO. QTY Description 677mm Frame Control Panel Refer to Drawing Hose, ¾ SAE-20R3 Gasket, Electrical Enclosure Divider To Engine AIR Intake 0C6946A Fuel Pump Assembly 023484F Snap Bushing 052219 1917 2118 11 29 32 33 QTY Description Complete Cylinder Block Cylinder Head Assembly Complete Crankshaft Idler Gear Assembly Rocker ARM Assembly Injection Pump Assembly Fuel Filter HOUSING, Timing Gear OIL PAN 1413 Appendix 5 Notes Manufacturers Warranty Coverage Federal and California Emissions Control Warranty StatementYour Warranty Rights and Obligations Parts CoveredObtaining Warranty Service Obligations and Rights of the Manufacturer and OwnerLimitations Warranty Schedule CONSUMER/PERSONAL Applications