Black & Decker LST136 Switching on and off, Power Command, Max Power / Max Runtime, Edging

Page 10

• Remove the battery from the tool.

 

• Press and hold the head release button (K1).

• While holding the auxillary handle, rotate the head counterclockwise.

• Release the head release button.

• Drop the edge guide (K2) in to the open position. Ensure that the

edging guide is all the way down, an audible click will be heard.

Note: The head will only rotate in one direction.

Note: The Auto Feed System may not operate correctly if edge guide is not used.

Switching on and off

 

• To switch the tool on, press

L

in and hold the lock off button

(L1) then squeeze the trigger

 

lever (L2). Once the tool is

 

running you may release the

L1

lock off button (L1).

• To switch the tool off, release

 

the trigger lever.

 

WARNING: Never attempt

 

 

to lock the trigger lever in the

 

L2

on position.

 

POWER COMMAND -

 

 

Max Power / Max Runtime

 

 

The max power / max runtime

M

 

feature (M1) is located on the

M1

tool handle. It allows you to

 

optimize the tools performance

 

 

and boost the power as needed.

 

 

• To choose max power to

 

 

tackle thick weeds, rotate dial

 

 

to setting 6.

 

 

• To choose max runtime to

 

 

increase battery life rotate dial

 

 

to setting 1.

 

 

• For a combination of both,

 

 

rotate dial to setting from 2 to 5.

 

 

OPERating the Trimmer

 

N

• With the unit on, angle unit and slowly swing the

trimmer side to side as shown in figure N.

 

 

• Maintain a cutting angle of 5° to 10° as shown

 

in figure N1. Do not exceed 10°(figure N2). Cut

 

with the tip of the line. To keep distance from hard

 

surfaces use edge guide (10). Pull the guide out

 

until it snaps securely into place

 

 

• Maintain a minimum distance of 24 inches

 

(609.6 mm) between the guard and your feet

 

as shown in figure N3. To acheive this distance

 

adjust the overall height of the trimmer as shown

 

in figure H.

 

 

 

N1

N2

N3

 

5O-10O

Edging

Optimum cutting results are achieved on

edges deeper than 2 inches (50 mm).

• Do not use the tool to create edges or trenches.

• Guide the tool as shown in figure O.

• To make a closer cut, slightly tilt the tool.

O

10

Image 10
Contents VEA EL Espanol EN LA Contraportada Save this manual for future referencePour LE FRANÇAIS, Voir LA Couverture ARRIÈre Table of Contents Important Safety Warnings InstructionsWatts MinutesCharge Indicator On/Off SwitchBattery Power CommandImportant safety instructions For battery packs Hot/Cold pack delay Charging ProcedureBad battery Leaving the battery in the chargerImportant Charging Notes State of charge indicator figure BInstalling and Removing the Battery Pack Checking state of charge during useAdjusting the position of the auxilIary handle fig. G Assembly & AdjustmentAssembly Tools Required not Supplied Attaching the guardEdging mode figure K Adjusting the height Tool figure HTrimming mode OPERATING INSTRUCTIONSMax Power / Max Runtime Switching on and offPOWER COMMAND OPERating the TrimmerCould be hazardous Replacement accessoriesREPLACING THE SPOOL REPLACING THE SPOOL Rewinding SpoolRbrc Seal Housing Check that the spool housingCarefully clean the spool Lever in the spool housing canTrouble shooting Overfeeding Line unravels when cap or spool is removedFull three-year home use warranty Mode D’EMPLOI Lignes directrices en matière de sécurité définitions Conserver ces mesures Nettoyage Adéquat AWG, American Wire Gauge calibrage américainMise EN Garde dans certaines circonstances, lorsque le Protéger le chargeur de la pluie et de la neigeCalibre de fil minimum recommandé pour les rallonges Directives DE Sécurité Importantes Pour LES BLOCS-PILESFonction de suspension du bloc-piles chaud/froid Procédure de chargePile en mauvais état Lorsque le chargeur détecte qu’une pile est excessivementRemarques importantes sur le chargement Installation du bloc-pilesPile laissée dans le chargeur La détente avant la pose ou le retrait de la pileFixation de la poignée auxiliaire figures F et G Montage et réglageFixation du pare-main figures D et E Régler LA Position DE LA Poignée Auxiliaire FIG. GRéglage de la hauteur de ’outil figure H Mode de taillageMode de coupe-bordures figure K Libération du fil de coupePuissance max./durée d’exécution max Mise en marche et arrêtFonctionnement DU TAILLE-BORDURES Coupe en bordureConsejos Útiles Para Cortar Accessories DE RECHANGERemplacement DE LA BOBINE figures P Et RLe sceau Srprc MC Rembobiner LA Bobine utiliser uniquement un filROND de 1,65 mm 0,065 po de diamètre figures S, T et U Black & DeckerEntretien INFORMATION SUR LES REPARATION Manual DE Instrucciones Si tiene una consulta o algún inconveniente con su productoProtector nunca utilice esta herramienta sin el protector Advertencias E Instrucciones Importantes Sobre SeguridadNo Opere herramientas eléctricas portátiles en atmósferas Componentes Guarde LAS Herramientas QUE no SE Utilicen ENConserve Estas Instrucciones Lea todas las instrucciones Procedimiento de carga Cargue los paquetes de baterías solamente en cargadoresBatería dañada Notas importantes sobre la carga Retraso por paquete caliente/fríoDejar el paquete de baterías en el cargador Indicador DEL Estado DE LA Carga Figura BPara Instalar EL Paquete DE Baterías Montaje y AjusteInstalación Y Extracción DEL Paquete DE Baterías Herramientas Necesarias Para EL Ensamblaje no SuministradasInstrucciones DE OPERACIÓN Modo DE Bordeado Figura K Encendido Y ApagadoMáxima POTENCIA/MÁXIMO Tiempo DE Funcionamiento Cuerda DE CORTE/ALIMENTACIÓN DE LA Cuerda Accesorios DE RepuestoFuncionamiento DE LA Podadora BordeadoREDONDA DE 1,7 MM 0,0065 REEMPLAZO DEL CARRETE Figuras P, Q Y RRebobinado DEL Carrete Utilice Únicamente Cuerda Pulgada DE DiámetroMuestra en la Figura T. Asegúrese de que MantenimientoLa línea se tensa contra el carrete como se Funciona lentamente DETECCION DE PROBLEMASLa herramienta La alimentación automática deProblema Esta Garantia no Aplica Cuando Solamente Para Propositos DE Mexico Page Cat. No. LST136 Form No Copyright 2013 Black & Decker
Related manuals
Manual 48 pages 8.15 Kb

LST136 specifications

Black & Decker has long been a trusted name in power tools and outdoor equipment, and their line of string trimmers is no exception. Among their notable offerings are the LST136, LST136-36V, and LST136R models. Each trimmer brings unique features and technologies to the table, designed to cater to a variety of gardening and landscaping needs.

The Black & Decker LST136 is a versatile cordless string trimmer powered by a 40V lithium-ion battery. This model is designed for ease of use and efficiency, making it an ideal choice for homeowners looking to maintain their lawns without the hassle of cords or gas. One of its standout features is the automatic feed spool, which ensures a continuous supply of line without the need for manual adjustments. Additionally, the trimmer offers a dual-line system for enhanced cutting performance, allowing you to tackle tougher weeds and thicker grass with ease.

The LST136-36V is a slightly more advanced version, boasting a 36V lithium-ion battery that provides longer run times and more power. This model is perfect for those who need a bit more oomph in their trimming tasks. It also features an adjustable height and handle, ensuring user comfort during extended use. The LST136-36V is designed for maneuverability, with a lightweight construction that makes it easy to navigate around flower beds, fences, and other obstacles in the yard.

Lastly, the LST136R offers a robust set of features, including a bump feed system that allows operators to release additional line with a simple tap on the ground. This model is also equipped with a 40V lithium-ion battery, similar to the LST136, and provides ample power for a variety of trimming jobs. The LST136R stands out with its ergonomic design, which prioritizes user comfort and reduces fatigue during long trimming sessions. Its built-in battery indicator lets users know how much charge is left, ensuring that you don’t run out of power mid-job.

In summary, the Black & Decker LST136, LST136-36V, and LST136R string trimmers each combine power, efficiency, and user-friendly features. Whether you’re a casual homeowner or a serious gardener, these trimmers provide reliable performance to keep your outdoor spaces looking their best. With innovations like automatic feed spools, adjustable settings, and lightweight designs, Black & Decker continues to lead the charge in outdoor power equipment.