Black & Decker LST136 instruction manual Important safety instructions For battery packs

Page 5

necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution.

An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.

Recommended Minimum Wire Size for Extension Cords

 

 

 

Volts

Minimum Gauge for Cord Sets

 

Total Length of Cord in Feet

120V

 

0-25

26-50

51-100 101-150

240V

 

0-50

51-100 101-200

201-300

Ampere Rating

American Wire Gauge

More Not more

Than Than

 

 

 

 

0

-

6

18

16

16

14

6

-

10

18

16

14

12

10

-

12

16

16

14

12

12

-

16

14

12

Not Recommended

 

 

 

 

 

 

 

Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.

Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat, stable surface (i.e., table top, bench top).

Do not operate charger with damaged cord or plug — have them replaced immediately.

Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service center.

Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly

5

may result in a risk of electric shock, electrocution or fire.

Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

NEVER attempt to connect 2 chargers together.

The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to use it on any other voltage.

SAVE THESE INSTRUCTIONS

Important safety instructions

for battery packs

WARNING: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

Read all Instructions

Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Li-ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

Image 5
Contents Pour LE FRANÇAIS, Voir LA Couverture ARRIÈre Save this manual for future referenceVEA EL Espanol EN LA Contraportada Important Safety Warnings Instructions Table of ContentsMinutes WattsBattery On/Off SwitchCharge Indicator Power CommandImportant safety instructions For battery packs Bad battery Charging ProcedureHot/Cold pack delay Leaving the battery in the chargerInstalling and Removing the Battery Pack State of charge indicator figure BImportant Charging Notes Checking state of charge during useAssembly Tools Required not Supplied Assembly & AdjustmentAdjusting the position of the auxilIary handle fig. G Attaching the guardTrimming mode Adjusting the height Tool figure HEdging mode figure K OPERATING INSTRUCTIONSPOWER COMMAND Switching on and offMax Power / Max Runtime OPERating the TrimmerREPLACING THE SPOOL Replacement accessoriesCould be hazardous Rbrc Seal Rewinding SpoolREPLACING THE SPOOL Carefully clean the spool Check that the spool housingHousing Lever in the spool housing canOverfeeding Line unravels when cap or spool is removed Trouble shootingFull three-year home use warranty Mode D’EMPLOI Lignes directrices en matière de sécurité définitions Conserver ces mesures Mise EN Garde dans certaines circonstances, lorsque le Adéquat AWG, American Wire Gauge calibrage américainNettoyage Protéger le chargeur de la pluie et de la neigeDirectives DE Sécurité Importantes Pour LES BLOCS-PILES Calibre de fil minimum recommandé pour les rallongesPile en mauvais état Procédure de chargeFonction de suspension du bloc-piles chaud/froid Lorsque le chargeur détecte qu’une pile est excessivementPile laissée dans le chargeur Installation du bloc-pilesRemarques importantes sur le chargement La détente avant la pose ou le retrait de la pileFixation du pare-main figures D et E Montage et réglageFixation de la poignée auxiliaire figures F et G Régler LA Position DE LA Poignée Auxiliaire FIG. GMode de coupe-bordures figure K Mode de taillageRéglage de la hauteur de ’outil figure H Libération du fil de coupeFonctionnement DU TAILLE-BORDURES Mise en marche et arrêtPuissance max./durée d’exécution max Coupe en bordureRemplacement Accessories DE RECHANGEConsejos Útiles Para Cortar DE LA BOBINE figures P Et RROND de 1,65 mm 0,065 po de diamètre figures S, T et U Rembobiner LA Bobine utiliser uniquement un filLe sceau Srprc MC Black & DeckerEntretien INFORMATION SUR LES REPARATION Si tiene una consulta o algún inconveniente con su producto Manual DE InstruccionesNo Opere herramientas eléctricas portátiles en atmósferas Advertencias E Instrucciones Importantes Sobre SeguridadProtector nunca utilice esta herramienta sin el protector Guarde LAS Herramientas QUE no SE Utilicen EN ComponentesConserve Estas Instrucciones Lea todas las instrucciones Batería dañada Cargue los paquetes de baterías solamente en cargadoresProcedimiento de carga Dejar el paquete de baterías en el cargador Retraso por paquete caliente/fríoNotas importantes sobre la carga Indicador DEL Estado DE LA Carga Figura BInstalación Y Extracción DEL Paquete DE Baterías Montaje y AjustePara Instalar EL Paquete DE Baterías Herramientas Necesarias Para EL Ensamblaje no SuministradasInstrucciones DE OPERACIÓN Máxima POTENCIA/MÁXIMO Tiempo DE Funcionamiento Encendido Y ApagadoModo DE Bordeado Figura K Funcionamiento DE LA Podadora Accesorios DE RepuestoCuerda DE CORTE/ALIMENTACIÓN DE LA Cuerda BordeadoRebobinado DEL Carrete Utilice Únicamente Cuerda REEMPLAZO DEL CARRETE Figuras P, Q Y RREDONDA DE 1,7 MM 0,0065 Pulgada DE DiámetroLa línea se tensa contra el carrete como se MantenimientoMuestra en la Figura T. Asegúrese de que La herramienta DETECCION DE PROBLEMASFunciona lentamente La alimentación automática deProblema Esta Garantia no Aplica Cuando Solamente Para Propositos DE Mexico Page Copyright 2013 Black & Decker Cat. No. LST136 Form No
Related manuals
Manual 48 pages 8.15 Kb

LST136 specifications

Black & Decker has long been a trusted name in power tools and outdoor equipment, and their line of string trimmers is no exception. Among their notable offerings are the LST136, LST136-36V, and LST136R models. Each trimmer brings unique features and technologies to the table, designed to cater to a variety of gardening and landscaping needs.

The Black & Decker LST136 is a versatile cordless string trimmer powered by a 40V lithium-ion battery. This model is designed for ease of use and efficiency, making it an ideal choice for homeowners looking to maintain their lawns without the hassle of cords or gas. One of its standout features is the automatic feed spool, which ensures a continuous supply of line without the need for manual adjustments. Additionally, the trimmer offers a dual-line system for enhanced cutting performance, allowing you to tackle tougher weeds and thicker grass with ease.

The LST136-36V is a slightly more advanced version, boasting a 36V lithium-ion battery that provides longer run times and more power. This model is perfect for those who need a bit more oomph in their trimming tasks. It also features an adjustable height and handle, ensuring user comfort during extended use. The LST136-36V is designed for maneuverability, with a lightweight construction that makes it easy to navigate around flower beds, fences, and other obstacles in the yard.

Lastly, the LST136R offers a robust set of features, including a bump feed system that allows operators to release additional line with a simple tap on the ground. This model is also equipped with a 40V lithium-ion battery, similar to the LST136, and provides ample power for a variety of trimming jobs. The LST136R stands out with its ergonomic design, which prioritizes user comfort and reduces fatigue during long trimming sessions. Its built-in battery indicator lets users know how much charge is left, ensuring that you don’t run out of power mid-job.

In summary, the Black & Decker LST136, LST136-36V, and LST136R string trimmers each combine power, efficiency, and user-friendly features. Whether you’re a casual homeowner or a serious gardener, these trimmers provide reliable performance to keep your outdoor spaces looking their best. With innovations like automatic feed spools, adjustable settings, and lightweight designs, Black & Decker continues to lead the charge in outdoor power equipment.