Arrow Plastic EH86S, WL86-A, VL8662-A, LM86, EH86-A, SA8662-A, ML86-A Anchoring Down The Building

Page 10

Anchoring

A10

Anchoring Down The Building

It is important that the entire floor frame be anchored after the building is erected.

Below are recommended ways of anchoring.

Arrow Anchoring Kit: (Model No. AK4 or 60298) Recommended for use with any suggested base. Contains: 4 Anchors with Cable, Clamps and installation instruction.

OVER THE BEAMS

AND INTO THE GROUND

Arrow Anchoring Kit: (Model No. AK100 or 68383) Recommended for use with the concrete foundation. Contains: Corner gussets, perimeter clips, hardware, 1/4" masonary drill bit and installation instruction.

AnchoringintoWood/Post:

Use 1/4" Wood Screws. There are 1/4" (0,63cm) dia. holes provided in the frames for proper anchoring.

1.2.

AnchoringintoConcrete:

1.For poured concrete slab or footing or patio blocks: Use 1/4" x 2" Lag Screws.

2.For Anchor Post of Concrete poured after building is erected: Use 1/4" x 6" Lag Screws.

1.2.

10

Image 10

Contents EH86S Before YOU Begin Plan Ahead Required Eye Goggles No Phillips ScrewdriverSafety First Care & Maintenance Other TipsAccessories Roof Strengthening heavy snow load KitsThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation For Your Building Foundation97 1/2 47m Anchoring Anchoring Down The BuildingHardware Parts List Assembly by Key No Place the front floor frames as StepFloor Frame Assemblies Overlap the rear floor frames asFrame Assemblies Overlap the rear wall channelRoof Beam Assembly Place the side wall angle, backDoor Track Assembly Using the door track spliceFloor Frame Position the rear corner panels at CornersPosition a front corner panel at Fasten the rear wall angle as Fasten the door track assemblyFrames Fasten the rear wall channel asWall Panels Door Jamb Gable Assemblies Gables/Braces Join the left and right gablesRoof Beams Right Roof Panel If a Roof Beef-Up Kit wasRoofAssembly FrontRidge Cap Roof Trim Put a horizontal door brace onto Door AssemblyHold the vertical door brace Attach the lower door guidesDoor Installation & Adjustment Repeat steps 1 through 3 for Left doorLM86 ML86-A SA8662-A VL8662-A EH86-AWL86-A