Arrow Plastic SA8662-A, WL86-A, VL8662-A, LM86, EH86S, EH86-A, ML86-A Care & Maintenance, Other Tips

Page 5

CARE & MAINTENANCE....

A5 Web

Finish: For long lasting finish, periodically clean and wax the exterior surface. Touch- up scratches as soon as you notice them on your unit. Immediately clean the area with a wire brush; wash it and apply touch-up paint per manufacturer's recommendation.

Roof: Keep roof clear of leaves and snow with long handled, soft-bristled broom. Heavy amounts of snow on roof can damage building making it unsafe to enter. In snow country, Roof Strengthening Kits are available for most Arrow Buildings for added protection against heavy snow accumulation.

Doors: Always keep the door tracks clear of dirt and other debris that prevent them from sliding easily. Lubricate door track annually with furniture polish or silicone spray. Keep doors closed and locked to prevent wind damage.

Fasteners: Use all washers supplied to protect against weather infiltration and to protect the metal from being scratched by screws. Regularly check your building for loose screws, bolts, nuts, etc. and retighten them as necessary.

Moisture: A plastic sheet (vapor barrier) placed under the entire floor area with good ventilation will reduce condensation.

Other Tips....

•Wash off inked part numbers on coated panels with soap and water.

•Silicone caulking may be used for watertight seals throughout the building.

Do not store swimming pool chemicals in your building. Combustibles and corrosives must be stored in air tight approved containers.

Keep this Owner's Manual and Assembly Instructions for future reference.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents EH86S Before YOU Begin Required Eye Goggles No Phillips Screwdriver Plan AheadSafety First Other Tips Care & MaintenanceRoof Strengthening heavy snow load Kits AccessoriesThis WAS Left Blank Intentionally This WAS Left Blank Intentionally 97 1/2 47m FoundationFoundation For Your Building Anchoring Down The Building AnchoringHardware Parts List Assembly by Key No Floor Frame Assemblies StepPlace the front floor frames as Overlap the rear floor frames asOverlap the rear wall channel Frame AssembliesPlace the side wall angle, back Roof Beam AssemblyUsing the door track splice Door Track AssemblyFloor Frame Position a front corner panel at CornersPosition the rear corner panels at Frames Fasten the door track assemblyFasten the rear wall angle as Fasten the rear wall channel asWall Panels Door Jamb Gable Assemblies Join the left and right gables Gables/BracesRoof Beams If a Roof Beef-Up Kit was Right Roof PanelFront RoofAssemblyRidge Cap Roof Trim Hold the vertical door brace Door AssemblyPut a horizontal door brace onto Attach the lower door guidesRepeat steps 1 through 3 for Left door Door Installation & AdjustmentWL86-A EH86-ALM86 ML86-A SA8662-A VL8662-A
Top Page Image Contents