Arrow Plastic WL86-A, VL8662-A, LM86, EH86S, EH86-A, SA8662-A, ML86-A owner manual Ridge Cap

Page 28

Step 15	● Parts Needed For ●
Step 15	Ridge Cap
B28

●8461 Ridge Cap (1)

1 Install the ridge cap on the com- pleted roof section using bolts and nuts. Do not fasten the ends of the ridge cap at this time.

2 Fasten the lower end of the panels

to the side wall angles using screws and washers.

8461

STEP

1

STEP

2

28

Image 28

Contents EH86S Before YOU Begin Plan Ahead Required Eye Goggles No Phillips ScrewdriverSafety First Care & Maintenance Other TipsAccessories Roof Strengthening heavy snow load KitsThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation For Your Building Foundation97 1/2 47m Anchoring Anchoring Down The BuildingHardware Parts List Assembly by Key No Step Floor Frame AssembliesPlace the front floor frames as Overlap the rear floor frames asFrame Assemblies Overlap the rear wall channelRoof Beam Assembly Place the side wall angle, backDoor Track Assembly Using the door track spliceFloor Frame Position the rear corner panels at CornersPosition a front corner panel at Fasten the door track assembly FramesFasten the rear wall angle as Fasten the rear wall channel asWall Panels Door Jamb Gable Assemblies Gables/Braces Join the left and right gablesRoof Beams Right Roof Panel If a Roof Beef-Up Kit wasRoofAssembly FrontRidge Cap Roof Trim Door Assembly Hold the vertical door bracePut a horizontal door brace onto Attach the lower door guidesDoor Installation & Adjustment Repeat steps 1 through 3 for Left doorLM86 ML86-A SA8662-A VL8662-A EH86-AWL86-A