Arrow Plastic LM86, WL86-A, VL8662-A, EH86S, EH86-A, SA8662-A, ML86-A owner manual Gable Assemblies

Page 23

Step 10	● Parts Needed For ●
Step 10	Gable Assemblies
B23

●7906 Right Gable (2)

●7907 Left Gable (2)

●7916 Roof Beam Bracket (4)

The gables go on top of the front and rear walls to support the roof beams.

NOTE

The gables are packed nested together and might be mistaken as one piece. Carefully separate them before continuing.

1 Attach the four roof beam brack-

ets to the gables using two bolts, washers and nuts.

NOTE

Mounting leg of bracket must face toward center of gable

7906

Washer

7916

Roof Beam Brackets

STEP

1

7907

23

Image 23

Contents EH86S Before YOU Begin Required Eye Goggles No Phillips Screwdriver Plan AheadSafety First Other Tips Care & MaintenanceRoof Strengthening heavy snow load Kits AccessoriesThis WAS Left Blank Intentionally This WAS Left Blank Intentionally 97 1/2 47m FoundationFoundation For Your Building Anchoring Down The Building AnchoringHardware Parts List Assembly by Key No Overlap the rear floor frames as StepFloor Frame Assemblies Place the front floor frames asOverlap the rear wall channel Frame AssembliesPlace the side wall angle, back Roof Beam AssemblyUsing the door track splice Door Track AssemblyFloor Frame Position a front corner panel at CornersPosition the rear corner panels at Fasten the rear wall channel as Fasten the door track assemblyFrames Fasten the rear wall angle asWall Panels Door Jamb Gable Assemblies Join the left and right gables Gables/BracesRoof Beams If a Roof Beef-Up Kit was Right Roof PanelFront RoofAssemblyRidge Cap Roof Trim Attach the lower door guides Door AssemblyHold the vertical door brace Put a horizontal door brace ontoRepeat steps 1 through 3 for Left door Door Installation & AdjustmentWL86-A EH86-ALM86 ML86-A SA8662-A VL8662-A