Arrow Plastic ML86-A, LM86 Frames, Fasten the rear wall angle as, Fasten the rear wall channel as

Page 20

			● Door Track Assembly (1)
	Step 7	● Parts Needed For ●	● Rear Wall Angle Assembly (1)
		Frames	● 8476 Side Wall Angle (2)
		Frames	● Rear Wall Channel Assembly (1)
	B20		● 9920 Side Wall Channel (2)

The main frame pieces give rigidity to the side walls and provide a surface for attaching the gables which sup- port the roof.

1 Fasten the rear wall angle as-

sembly across the inside top of the rear wall using screws.

2 Fasten the rear wall channel as-

sembly across the middle of the rear wall using screws.

Wall Angles

Must Face

Inside

Building

STEP		STEP

1		2

	8476

6615

9924

FRONT

3 Fasten the side wall angles across the inside top of the side panels us- ing screws. Side wall angles must overlap rear wall angle in corners.

4 Fasten the side wall channels

across the middle of the side panels using screws. Fasten overlaps in rear corners with screws.

STEP

3

STEP

4

9920

FRONT

5 Fasten the door track assembly

(holes on top) across the top of the front wall panels using screws. See the figure.

9378

DOOR TRACK ASSEMBLY

FRONT

Long Leg on Top

Opening

Facing in

Short Leg on Bottom

STEP

5

20

Image 20

Contents EH86S Before YOU Begin Plan Ahead Required Eye Goggles No Phillips ScrewdriverSafety First Care & Maintenance Other TipsAccessories Roof Strengthening heavy snow load KitsThis WAS Left Blank Intentionally This WAS Left Blank Intentionally 97 1/2 47m FoundationFoundation For Your Building Anchoring Anchoring Down The BuildingHardware Parts List Assembly by Key No Step Floor Frame AssembliesPlace the front floor frames as Overlap the rear floor frames asFrame Assemblies Overlap the rear wall channelRoof Beam Assembly Place the side wall angle, backDoor Track Assembly Using the door track spliceFloor Frame Position a front corner panel at CornersPosition the rear corner panels at Fasten the door track assembly FramesFasten the rear wall angle as Fasten the rear wall channel asWall Panels Door Jamb Gable Assemblies Gables/Braces Join the left and right gablesRoof Beams Right Roof Panel If a Roof Beef-Up Kit wasRoofAssembly FrontRidge Cap Roof Trim Door Assembly Hold the vertical door bracePut a horizontal door brace onto Attach the lower door guidesDoor Installation & Adjustment Repeat steps 1 through 3 for Left doorWL86-A EH86-ALM86 ML86-A SA8662-A VL8662-A